Need help. FJ80 Tie Rod Insert

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

A lot of vendors sell new complete beefier units that might be almost as cheap. I've been looking at the ones at Marlin Crawler.
 
I have looked at the aftermarket units, but the problem is I have OTT steering arms on my truck so it changed the length that I would need. I am also building my Tie Rod, and Drag Link out of heat treated 4130. I had tried to buy a Marlin Tie Rod in the past (during the move) and I waited almost 5 months. I got some run around and it never showed.

Ryan.

A lot of vendors sell new complete beefier units that might be almost as cheap. I've been looking at the ones at Marlin Crawler.
 
Ryan, is there a reason you're wanting to use the 80-series TRE's? I'd understand if you were completely set on using Toyota stuff where ever possible but given the amount of fabrication and modification and the fact you are going to end up with 37's or bigger why don't you use the GM 1-ton TRE stuff? Good luck though, your steering set up will be interesting for sure! :cheers:
 
If you do for some reason decide to retaper the arms for GM stuff, make sure the reamer is straight when you do so. Otherwise the castle nuts won't sit flush against the bottom of the arm. Don't ask me how I know :doh:
 
Back
Top Bottom