Material for Shackles

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 6, 2005
Threads
59
Messages
1,155
Location
Menlo Park, CA
I am going to make some longer shackles for my cruzah.. 6" eye - eye

would 440C stainless (3/8 thick) be ok to use?

or

303 or 304 stainless(1/2 thick or 3/8) be ok

I know that 303 can be on the soft side.

Also 4140 i could get.. hmm talking like Yoda I am....

What do you all think? If not these what kind of material would be good to use?

I know people say cold or hot rolled BUT what is the actual name or # of the material being rolled is what I'm interested in or can't find out...


Thanks
 
Last edited:
A buddy made mine from 3/8" hot-roll...only one issue:
One or Two have developed some grooving in the bolt-hole.

I may upgrade to 1/2" when I replace these.
hth,
manny
 
Generic rolled steel in 2 inch by 3/8

Weld the bolts into one side, to emulate the OEM approach (splined into one side). You don't want the bolts to rotate in the side plates, you want the bushing to rotate on the bolts.


Mark...
 
good info thanks you guys...

Now to check if 440c is rolled or not..
 
Last edited:
Back
Top Bottom