$%^$#$@#%&*!!!:mad:

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 30, 2004
Threads
59
Messages
362
Location
Sacramento, CA
Dang it! I have been trying to get these spare axles apart for HOURS now and I just can't! Does anybody have any tips on how to get them apart? I've got two early front axles and a early rear axles that I have been trying to get apart , and I just can't. :o Otherwise, the things are going in the bin. I'm in Sacramento, you can come over to help if you want, or even to pick some up, just let me know.By 6:30 I'll be done!
 
ONCE THE FRONT IS TORN DOWN, THE BIRF HAS A FLAT SPOT(caps) :mad: that needs to be rotated so it slides out.
the rears, remove c-clip out of the diff and pull
if your trying to do it with the brake drum on, you will prolly have to back off on the shoes so the drum will clear them.
 
freaking everything. 2bad, you angry at me or recalling an incident you had yourself? These things had been sitting for who knows how long in the mud, rain, snow, etc. I have gotten pretty much every single freaking nut possible off, just can't seem to break seals or whatever else it is that is holding things together. Thanks for the help
 
also, I am extremely inexperienced when it comes to axles right now. Through these I would like to learn a thing or two. we'll see how that goes...
 
where are you at in Sac? If you are anywhere near Sunrise and 50 or Elk Grove, I might be able to swing by and help you. I am at work until 5 though.
-Brian
 
yup, i've undone all of the bolts, i think that its just, well, i don't know exactly what it is. Thanks for the link, and bsilva, I'm just a little west of Sunrise off of 50, where 50 meets Watt. Thanks for offering, but I'll be cleaning up around then. thanks for the help guys, and wish me luck.
 
well, I'm throwing in the towel. The things are completely rusted together. I've never seen anything like it. I've banged pulled, prodded, twisted, yanked, and done anything else to these things and they just won't come apart. It's alright though, I've come to terms with it. And I have justified giving 'em up. My cruiser is newer axles and parts anyways, they were older style. its okay, its okay... anyway guys, thanks for the help, now I'll just start building up my cut and turned axles for the SOA... i'll keep you posted up on those. even though you guys have probably read a billion of 'em as it is.
 
So what are you going to do with the old ball and Claw shafts???
 
I tried too, even printed the directions out, but they are for newer axles (with disks) and I'm dealing with drums both front and back. Just wanted some experience, so now I've learned how to not tear down an axle.
 
i'm guessing you got the outer shaft of the ball joint front end off (.that should've fallen off) and it's the inner you're having problems iwth...

it's possible thatthe brass bushing has seized to the axle shaft...mine did that...and it will do it again since it was a tight fit going back together with the new bushing, but i have a spare ball joint front end, so i don't really care.

i used a pry bar though the trunnion bearing hole to get mine out.
 
my64fj40 said:
You need some???
yeah, I have a 454 powered cruiser on 44's and the ball and claw shafts are the only ones that seem to hold up for me :)
 
Back
Top Bottom