low oil pressure

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 6, 2015
Threads
14
Messages
39
Location
El Paso, Tx
So i just got a new engine (used engine) had it installed and now the engine starts with high oil pressure then goes to L for low oil pressure. When it gets that low it starts to act like it wants to cut off. Any idea what is going on? replaced the oil sender. Need help Plz
 
At what rpms is this happening? I personally don't put a lot of faith in the factory Guage.
 
I would seriously recheck again with a mechanical Guage. They are cheaper than another new engine.
 
You should have at least 10 psi of pressure for every 1k rpm but it can be a bit lower as long it stays above 5 psi and pressure should rise quickly when rpm is up and should stay with in 20 to 30 psi at 2k rpm. Yes get a manual gauge.
 
You should have at least 10 psi of pressure for every 1k rpm but it can be a bit lower as long it stays above 5 psi and pressure should rise quickly when rpm is up and should stay with in 20 to 30 psi at 2k rpm. Yes get a manual gauge.
thanks a lot and i have to go buy one now bc no auto parts store has one for me to use
 
A cheapie mechanical gauge (as long as it has enough needle sweep to be readable) should work fine. You don't need to spend a fortune on a mechanical gauge that will be used just a few times for diagnostic purposes.
 
No problems with your oil pressure - those are very typical numbers, IMO. You won't see 'too high' in a stock Toyota, really - unless something is way out of whack.

If you don't like your dash gauge readout, then you have a gauge issue. Test your new oil pressure sending unit according to the FSM and test your old one (if you have it) to rule those out. After that, it's the dash gauge or an inst. panel voltage regulator issue.
 
No problems with your oil pressure - those are very typical numbers, IMO. You won't see 'too high' in a stock Toyota, really - unless something is way out of whack.

If you don't like your dash gauge readout, then you have a gauge issue. Test your new oil pressure sending unit according to the FSM and test your old one (if you have it) to rule those out. After that, it's the dash gauge or an inst. panel voltage regulator issue.
thanks a lot you have been a big help. Im going to drive it and my sure it does not act up on me
 
Last edited:
Are your readings hot or cold? What is your readings when hot at idle and cruising speed?
 
That is good reading,if you are running the manual gauge please toss the plastic or nylon tubing it came with and get something better.
 
Back
Top Bottom