loosen spring clamps

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

890man

SILVER Star
Joined
Jul 7, 2005
Threads
90
Messages
867
Location
Thousand Oaks, Ca.
I searched and saw posts about loosening spring clamps for better articulation but didn't see how to do it. This stuff is thick and doesn't like to bend where I want it to. I was thinking of adding heat with a torch and a fine tip to keep the heat on the bracket and not the spring. It sure would be easier than bending, pounding and cursing and still having them look like s***.
 
Yea, I can see how pounding them flat on an anvil would work great but I plan on doing them on the truck.
 
890man said:
Yea, I can see how pounding them flat on an anvil would work great but I plan on doing them on the truck.
Why not pull them and clean/grease everything up as long as you are trying to improve articulation? You will be amazed at the amount of gunk between the leaves when you pull the spring pack apart.

BTW There was a good article in Toyota Trails a while back with a lot of tips on simple things you can do to improve articulation.
 
A very large crescent wrench will also work, say >15". Like the 18" I found on the road! :D :D

Another great side benfit of riding a motorcycle! I'm always finding tools.
 
big hammer some giant vise grips and a pry bar should be plenty
 
Yea, I found a nice big craftsman wrench the other day. It had been run over and bent a little. I'll take it back soon to get it "replaced":D
 
It may be time to pull the packs and clean. I have read about slip coat (I think thats what it is) and something jt outfitters sells. Some type of plastic insert. Must be teflon or something slick but I don't know how long those will hold up. Tap plastic may have something cheaper. I have three clamps on each spring so they shouldnt fan out. Would por-15 work as a durable coat for springs?
 
are you looking to get more flex? only so much you can do without a complete modification ie.. soa?
 
It's a bit hard to explain the technique, but with a flat crowbar (like a "wonderbar") and a hammer you can bend them nice and straight while still on the rig. It's really pretty easy and doesn't take long.


Mark...
 
Last edited:
cool, I'll try the crowbar first then move to the torch when I get frustrated. I am just looking to free everything before I max the suspension out with the fork lift to measure for new shocks. I want to have the new shocks here before I install the ford towers which will happen right after the scout p/s install which will happen right after the 4wheel disc install all of this followed by a dual batt tray, front bumper and 8274 install. Take a breath and move on to the next project. BTW, this is my daily driver.:D
 
Back
Top Bottom