Is my front diff to shiny?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 17, 2004
Threads
12
Messages
187
Location
Sedro Woolley WA
Is my front diff to shiny? (Axle rebuild)

I was thinking the Cruiser needed a little more bling. :flipoff2:
Axle002.jpg


Actually, I'm rebuilding an axle out of a 69 FJ40 to replace the stock 65 axle in the cruiser right now.

I'm doing a mini disk swap, and going spring over.

It's nice to having an extra axle to work on so the down time on the cruiser is at a minimum.

Yes I will be painting the axle.

Here is what I started out with.

Axle001.jpg
 
Last edited:
I have to admit, it looks a lot shinier in the picture then in person.

I spent about 4 to 5 hours sanding the crud, rust and old paint off.

I used a cup style wire brush and a Scotch Bright disk, both that fit in my 1/2” drill, but the thing that did the most good was an 80 grit sanding disk that attached to my 4 ¼” angle grinder. I went through 2 of those before I called it good.
 
Like a diamond in a goat's ass!

Use some "Metal Prep" on that schtuff to get good adhesion.

Looks Great!

Ed
 
Are those chain hooks on the top of the housing? Did you add those? Good idea.

Ed
 
Degnol said:
Are those chain hooks on the top of the housing? Did you add those? Good idea.

Ed

I use 10,000lb rated axle straps, one at each corner, when I trailer the cruiser. A buddy of mine works at a metal shop and he came up with those. It will be easier to attach the D hoop on the strap to the hook on the axle then to loop the strap around the axle.
 
tucker74 said:
Did you cut and turn the axle?

Tucker

No - I tilted the pinion 6*, when I get done with the SOA, I will be close to the same hight that I am now. (4" Skyjacker springs and 6" shackles). It tracks and turns fine at this time, if I have problems I will pull it apart and then cut and turn.

My rig mostly sees trail too.
 
Back
Top Bottom