Intake cleaning w/Pics

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 24, 2013
Threads
87
Messages
1,155
Location
Santa Monica, CA
Not sure how many of you are familiar with "Vapor Honing" (www.vaporhoningtechnologies.com), but I decided to clean my intake manifold and used the booth we have at work. It's actually an old-school technique that uses a slurry of blast media and water. Sorry I don't have any good before shots, but you can imagine what a 200k mile intake looked like. Call me impressed at what 15 minutes can do.

The quest to defeat P0401 continues. New EGR, VSV, and all new vacuum lines for the reassembly.

26512332900_bcea758680_b.jpg

26784978575_b72857b21a_b.jpg

26179530684_b6d54aab52_b.jpg

26691262542_5c5139d2aa_b.jpg

26717952421_34ef18b76f_b.jpg
 
wow, nice!

My P0401 is being caused by plugged ports in the throttle body. One is completely clogged and I can't seem to clean it from the outside. I'll have to remove it and clean it out one of these days.
 
Very Cool Technology.
Does it use same abrasive as Sand Blasting?
Is it gravity fed or does the water create a Venturi?
 
Very Cool Technology.
Does it use same abrasive as Sand Blasting?
Is it gravity fed or does the water create a Venturi?

Water and standard bead blasting media. You can use ceramic or glass. The water essentially cushions the impact on the metal surface, so you get a "honing" effect rather than a "shot peened." There is zero surface degradation. It won't change the surface texture of a machined surface. All runs though a high pressure pump.
 
Could that intake be completely coated with some type of ?ceramic coating to seal up the "pores" of the aluminum casting??
 
What I wouldn't give for anything on my truck to be that clean. Espec on the inside. That's bonkers. I love it.
 
Nice hood strut you got there.
 
Back
Top Bottom