i hate pink!!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 30, 2003
Threads
647
Messages
16,635
Location
windy wyoming
any of you that use bondo in large quantities please slap yourself now.

i still haven't gotten all of the 50 pounds of bondo off the 74 tub that i put on my 68, now, i found this on the pig
P5150007.webp
P5150009.webp
P5150015.webp
 
Ige,
Bondo...plastic filler, should be no more than 1/8" thick. That's what I've always been told and tried to subscribe to. That older cruiser metal is thick and a bitch to beat back, especially in a bend or curve with tight access. A slide hammer helps sometimes, as does a torch.

GL

Ed
 
Degnol said:
Ige,
Bondo...plastic filler, should be no more than 1/8" thick. That's what I've always been told and tried to subscribe to. That older cruiser metal is thick and a bitch to beat back, especially in a bend or curve with tight access. A slide hammer helps sometimes, as does a torch.

GL

Ed
i didn't do it...this was a p.o. modification...i avoid it like the plague..i'd rather just paint over the dents. they're character anyways.
 
Yeah I hate bondo and fiberglass. When I have my body re-done will tell the shop NOT to use either. If you can not get it looking pretty without bondo or fiberglass guess I need to take it to a new shop. If I come to pick it up and run my magnet along side of it and if it loses attraction I want it done over...free since I told you NOT to use either. That is how badly I hate it. Rather drive it around being able to see the weld seems than have bondo covering it up only to chunk off in a few years.

Good Luck with all of it. Sorry to see that. Sucks.
 
why do we hate

Plastic body filler such as 3m Rage fillers when used properly with proper prep work. will last decades. Come on when you watch American Hot Rod, and they use it on those high dollar rods, surely we can smooth some to smooth a few cruiser pannels. So don't hate Plastic Filler hate the A$$ H@LE that did the crappy work with crappy Walmart Bondo brand filler. ;)
 
So....

That huge rust spot under that bondo, was that caused by improper preparation, not sealing it all the way around, or did moisture just seep through that crap?

Tried bondo once on the front fenders of the old 40, after a month it shrunk and cracked. I'll try my luck with welding in new steel and sanding it smooth next time.
 
Hi All:

Sorry you are still having "Bondo issues" Ige!

I swapped out the body tub on my '74 FJ40 b/c of the huge rust holes the P.O. had covered with bondo. The replacement '68 tub has a little bit of bondo on it I applied strictly to smooth out panels - not to cover any rot!

Keep up the good work of restoring that FJ55!

Regards,

Alan
Seattle
 
unfortunately, restoration is waaaayyyy beyond my patience level...if i can just get it and the 45 runnng in the next decade or so, i'll be thrilled :bounce2: :bounce: :bounce2: :bounce:
 
I feel your pain! I'm in the middle of the same scenario, bondo, expanding foam and fiberglass.
I did uncover a couple of other surprises though. I was grafting new steel on the windshield pillar and ran across an area that was leaded. Not sure if that is factory or not...............Even had lead on the rear wheelwell lips..................
 
Back
Top Bottom