How much does an axle weigh?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 16, 2003
Threads
156
Messages
1,032
Location
Olympia, WA
Website
www.myblueheaven.com
Looking at putting together a work bench to do my axle rebuild on (front axle from a 1978 FJ40) and am curious as to how much that thing will weigh. I want to put casters under it, but want to make sure I build it beefy enough.
 
I had a front axle shipped to me, I think the total weight (with pallet) was around 380 lbs.
 
perfect timing, I just got back from Tucson where I picked up a front axle FJ60 for Disc brake swap. I am not sure of the precision of my measurement device but I think it read freaking heavy!

The two of us slide it from his truck to my matrix, ( bad choice for delivery vehicle) got it home and used the engine hoist to get it out.

300 lbs sounds about right.
 
Looking at putting together a work bench to do my axle rebuild on (front axle from a 1978 FJ40) and am curious as to how much that thing will weigh. I want to put casters under it, but want to make sure I build it beefy enough.
Have you thought about just using a set of the Harbor Freight 6000# jack stands? Maybe use a third one under the diff to steady it? They're on sale! John
 
idea

I needed a way to transport my axle from a friends house where I was going to rebuild the axle, and my place without bending up the disk brake backers like the PO did, so I build this quick and dirty bench setup. It really is just a piece of sheet wood, I used MDF scrap, and some 2x4s. I set it up high enough so that I had room to do all the work. Around the spring perches, I put wood on the sides to be able to "lock" it in place. We have used it on a couple axles now, transports great, and I am able to throw a furniture dolly under it to move it around.

Cheers.
Picture%205074.webp
Picture%205079.webp
 
Have you thought about just using a set of the Harbor Freight 6000# jack stands? Maybe use a third one under the diff to steady it? They're on sale! John

Hey John,

That was my initial plan, and even had it setup on a couple on my garage floor, but I really want to get a little higher off the floor, and I also want to be able to move it around. I have a steel framed work bench on casters that I am going to put it on today, just wanted to make sure that it would support it. :-)
 
Here is what I came up with.
I WAS gunna offer to drop by and help lift, but it looks like ya got the job dun without me! Looks good to me. Last winter I did the front axle rebuild, including the 5th stud on the top of the knuckle, while still attached to the Piggy, and just sitting on stands. My butt still hurts from sitting on cold concrete. John
 
I WAS gunna offer to drop by and help lift, but it looks like ya got the job dun without me! Looks good to me. Last winter I did the front axle rebuild, including the 5th stud on the top of the knuckle, while still attached to the Piggy, and just sitting on stands. My butt still hurts from sitting on cold concrete. John

Would have never happened without a hoist. :-)

You are always welcome over, have missed chatting since I haven't been to a monthly meetup in a number of months now.
 
Back
Top Bottom