How do you remove the gear shift lever?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

med-large slipjoint pliers has always worked for me....make sure yer in neutral too...,

boot off, adjust the slip so it's about 1-1/2" wide, press down, rotate...the teeth will grip the cap and rotate it, but you may bugger it up a bit.
 
Just about any tool (ie. a few inch long piece of aprox 3/4 or 1" ID tubing) that will slide over the shift lever itself, and allow you to push down on the cap (the part you're trying to remove) will work. The hardest part is knowing that after you push the cap in (it's spring loaded so you'll have to 'giver) you need to turn clockwise to get it out (Left hand thread can be a bi*ch) just like roger said.
 
I've used my hand, and I've used a spring shackle bushing with a piece of wood that has a hole in it to push and turn and save the hurt on my hand.

Not all turn clockwise for off - older 3 speed has counter clockwise off, or at least my '65 does.

So the hardest part is to remember which way to turn which one.
 
Last edited:
This is the SST Toyota recommends:

81_1_b.JPG


It doesn't look too hard to make.

Dave
 
well if I would have seen a picture like this I could have gotten it off in about five seconds. Ended up taking 15 min. :doh:
Thank for the advice though. I was trying to turn the shifter. :doh:
IMG_2577.JPG
 
Back
Top Bottom