Holey Header Batman!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 26, 2004
Threads
233
Messages
5,819
Location
Utah
Argh. I noticed my exhaust getting louder and have found pin-hole sized openings in my downpipe, by the 02 sensor.

The exhaust shop I took it to didn't really recommend just welding the holes up- they recommended replacing the down pipe. They can make me a new one if they have a replacement 02 bung...

Does anyone sell replacement downpipes/ 02 bungs?
 
Slee:
Slee - Drivetrain - Drive Shafts

Weld on Oxygen Sensor Bung
Part#: SOF1097 - $27.50

If you have ever done a custom exhaust on a Toyota vehicle, you will know that the stud style O2 sensor bung is not available to buy. Now you can save hours of cutting and grinding to save that old rusted piece, by using one of our machined bungs. It is supplied completed with new Toyota oe studs and nuts.

The bung is machined to fit 2.5" exhaust tubing, but with minimal grinding can work for any tubing from 1.5" up.
 
Put your bung http:JEGS O2 Sensor Weld Fittings - JEGS
55530740.jpg


into this:
Flowmaster Y-Collectors - JEGS
389Y214300A.jpg
 
Thanks guys- I told the exhaust guy that I'd figure something out quickly once it was posted on MUD.
 
I've seen an engine swap where a guy drilled out some 'spark plug non-foulers' and used them as O2 bungs. You'd just have to match up the threads, and they are available at any of the chain auto parts stores.
 
unless im misreading what your describin, i think the issue is that the OE oxygen sensors are not threaded.
 
I have made my own bung and have cut the old bung out and reused it (have cut it out twice and rewelded it in as I have redone my exhaust 3 times over the past 3 years)

You can cut the old pice out with a 4" grinder in the time it took me to post just now. you can even reuse the gasket if its not all tore up and it probably isnt. I have been using same gasket since the start.

you can make your own flange in 10 minutes.

not rocket science
 
Back
Top Bottom