Well, another problem with the tcase rebuild. I'm trying to replace the small cylinder shaped bearing at the end of the large shaft and pretty much trashed the whole thing.
The race is stuck in there and I've tried using cold chisels to cut it out but the thing just laughs at me.
Any suggestions on getting what's left out of there? I'm going to try a dremel next. Hopefully I can get somewhere with that.
Thanks in advance.
The race is stuck in there and I've tried using cold chisels to cut it out but the thing just laughs at me.
Any suggestions on getting what's left out of there? I'm going to try a dremel next. Hopefully I can get somewhere with that.
Thanks in advance.
