Head light mystery, help!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Just an update on this problem. I ordered a new fuse block and wire blocks from CDan. I put in the wire blocks and the headlights still didn't work. I then put in the new fuse block, and cleaned/redid most of the connections to the block. The headlights work now, and brighter than before. Also, the wiper motors work a little better too. Putting in a new fuse block was definatly a great investment. Thanks for all the help guys. Now if I can just figure out why my cruiser wont stop running when I shut off the ignition switch. :D
 
:beer:
 
warpdriv said:
I had a bad ground in my harness, so I ran the ground straight from the light to the body. Then they worked. Try making a jump wire to so if you are having the same problems.

hth,
Exact same story for me. Cost me 20 minutes and about .79c. So when your lights quit on you again, try fixing the ground! .02 :)
 
zaskar_ofn said:
Keep on tracing the problem. Advise: install relays to take care of the laod in your circuit.
You should have had the problem I had a while back. My headlights would not work with the engine running but the moment I turned the engine off the lights started working again.


Putting relays into headlight circuits is a good thing. OEM headlight wiring is often 18 gauge and that's only good enough in a perfect non resistive circuit. Old cruisers seldom have perfect circuits. So use the OEM wiring from the switching to energize a relay that routes battery current through larger short wires of maybe 10 gauge, or 12. You've never seen such bright headlights! This is the same sort of setup you'd get in the box with an aftermarket (like Hella) halogen headlight upgrade.

Seems like I saw a tech link here that discusses this stuff in depth.
 
Back
Top Bottom