Head Gasket replacement instructions

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 8, 2006
Threads
100
Messages
501
Location
Chadds ford, pa
Hello,

I am replacing the head gasket on my 2f. I have pulled the valve cover and manifold. What are the next steps. Do i need to pull the valve guides? if so which bolts?

Thanks!!
 
Thanks. Which bolts for the rocker arms. do I loosen the bolts that are directly above the guides. The ones slotted for a screw diver or the two that are parrallel two eachother one of which is the rocker cover bolt.
 
The slotted screws are just adjusters and you don't need to fool with them. Valve guides are the bronze bushings that the valve stems slide in and they aren't removeable until the valve is out.

You might as well have your machine shop do a valve job too while you have the head off. They can replace the valve guides.
 
so i just need to remove the series of two parellel bolts along the length of the head one of which is the rocker cover bolt.
 
calsum2 said:
so i just need to remove the series of two parellel bolts along the length of the head one of which is the rocker cover bolt.
You've got it.
 
Make sure you put the head gasket on properly. It only does on one way. If you put it on upside down you will block the only oil passage that feeds the rocker arm. The head gasket should be maked which side is up. Or find the oil passage in the gasket (a hole with a copper rim).
 
Back
Top Bottom