Harness layout (showing physical connector locations, not just the schematic) - BJ40 - 24V - Belgium

[BartST]

I have a BJ40 Diesel (B engine) 24 volt, EU car and I/ struggling with the wire loom. I found the image below

Who could help me with a higher resolution image of this?

https://globalsoftware-inc.com/coolerman/fj40/schematics/BJ40/1981BJ40_BJ43_HJ47/1979%20BJ40%20series%20USA%20amp%20Canada%20Harness.JPG

Would be tremendous

Thanks

Bart

 

[charliemeyer007]

On a laptop w11 pro zoomed to 300% I can read everything on the screen but need to use the cursor control to move around. It would take several screen shots to capture the complete image. Then you would need to print them, cut and past together.

Much easier to take the file on a chip/card/or email to a local copy enter and have them print it on a big sheet of paper 18"x24" or 24"x36" for a few bucks whatever that is in metric.

 

[BartST]

On a laptop w11 pro zoomed to 300% I can read everything on the screen but need to use the cursor control to move around. It would take several screen shots to capture the complete image. Then you would need to print them, cut and past together.

Much easier to take the file on a chip/card/or email to a local copy enter and have them print it on a big sheet of paper 18"x24" or 24"x36" for a few bucks whatever that is in metric.

View attachment 4132018

Thanks!!

 

[BartST]

Thanks!!

Tried but is far from optimal. Anybody with a better copy out there? Thanks