Hardware. Just how hard is it?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 1, 2006
Threads
447
Messages
1,858
Location
Dallas
Website
www.octagonmma.com
So, some here have indicated bad results with Bolt Depot purchases, and not to buy there.

Allen, Fastenal, McMaster Carr or the like is preferred over the former.

My question is, "ain't all 10.9 steel bolts the same?"

Anyone care to shed some light on how a standardized metal content and hardening process used on said bolt could differ substantially from vendor to vendor? I'd bet one manufacturer or two make all these bolts anyway.


Please advise.
 
the problem with bolts.......typically the metal used all the different bolts is inconsistent. I am not "up" on the 10.9 steel bolt. If that is a bolt rating then they should all be with in a probably 10 percent of each other(strength both tensile and shear). The allowable loads on the bolts is factored down due to the inconsistencies in the bolts materials. I have seen large descrepencies in bolts of the same type pulled out of the same box from the manufacturer.

doubt that helps any

lunyou
 
Depending on your application, you may need to be more concerned with corrosion resistance than tensile strength & hardness. Wherever I had fasteners extending through the body to outside I used stainless steel. You have to be careful with it, thread only into clean threads because SS is pretty soft and galls easily. Once SS strips threads you're screwed (pardon the pun). Otherwise I use yellow cad plated. FYI, don't use Stainless for engine assembly, it lacks the hardness. Now for bumpers, tow hooks, suspension, etc. I use grade 5 or 8 hardened alloy fasteners. My 2 cents
 
I do not care what the marking is on the bolt. There are tons of threaded fasteners that ship from China that do not meet the specifications that they are marked with. The company that I worked for did lot testing of all hardware that was to be used in the assembly of our products (tactical missiles) and found that the hardware that failed tended to be from China. Personally, I call and find out what the country of origin is for critical fastners I'm buying. I've been very happy with the hardware I get from McMaster-Carr.
 
That was all I had to hear. If it's good enough for our missiles, it's good enough to be in my cruiser.
 
I've found the hardened bolts from ACE tend to be much better than those from the big box stores (again, probably country of origin).
 
Back
Top Bottom