getting BDS to flex

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 12, 2005
Threads
287
Messages
3,081
Location
Littleton, Colorado
Ok, as most of you know, i have the BDS 4in lift on my cruiser. and its stiff, and barely does anything on the trail. so i read about someone with a set of rancho lift springs, who took them apart, sanded them and painted them with sometype of teflon paint and put a lubricant inbetween all of the springs and pads. he said after he did this that his ranchos were super flexy. i was just wondering if you guys think this is worth while on my BDS springs. or would i just be wasting my time by doing this?
 
I've heard of people buying bags of concrete and putting them in the back.

The paint is probably "Slip-Plate". It is a graphite based dry film lubricant. I know that Tractor Supply carries it. You may also find it at John Deere or CAT dealerships. Comes in a can or spray paint too.
 
74fj40 said:
Ok, as most of you know, i have the BDS 4in lift on my cruiser. and its stiff, and barely does anything on the trail. so i read about someone with a set of rancho lift springs, who took them apart, sanded them and painted them with sometype of teflon paint and put a lubricant inbetween all of the springs and pads. he said after he did this that his ranchos were super flexy. i was just wondering if you guys think this is worth while on my BDS springs. or would i just be wasting my time by doing this?
Most of what that person did was of a temporary fix at best. Putting plastic disks between the leafs will reduce the friction between the leafs and allow them to slide easier. This is what OME does. You need to select a plastic that has good impact strength, low friction, UV resistance and a temperature range that will not soften the plastic as the springs heat up from the flex and friction. PTFE sheets would be my first choice. How you attach them is a whole other issue (short flathead screws?). If your springs are too stiff after breaking them in, them I would be inclined to removing a leaf at a time till you get the flex you are looking for. There is an individual here in Tucson that has removed two leafs from his 4” OME springs and has a very flexible system with only a minor loss in ride height (less than 1”).
 
I"ve got Belton springs on my rig and when new 3 years ago it was the harshest ride imaginable. It was unbearable. I took 2 springs out of each pack and it made a big difference. Two years later I put one spring back into each pack to regain a little lift it had lost and the ride is good. I would never buy Belton again but had to make the best of the situation. The Teflon idea sounds interesting, what have you got to loose? :)
 
I had the 4" BDS system..... I am now SO and the ride and handliung is 200% better on road and off.
But thats another story. I had the same problem and tried removing some of the shorter leaves without much success. If I was to do it again, I would remove the second, double military wrap leaf on all 4 corners. Then load it up with a weight simular to camping/wheeling and work the springs hard on a washboard road or rutted road. Be relentless, the springs are.
PMK
 
Back
Top Bottom