Gearing Recommendations (R&P)?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 19, 2006
Threads
254
Messages
2,013
Location
Tulsa, OK
Website
www.cardomain.com
I've about talked myself into a re-gear (4:88) and started searching a bit. My local shop freaked on the "Lexus" factor and told me they didn't want to get into "that".
Called Randy's R&P and they freaked on the "e-lockers"; I wasn't aware (and don't think) that has any effect on the R&P set.

I did come across an article in 4wd Toyota Owner mag that got their expedition 80 diffs done at JT parts and accessories. Called them and they said no prob. Once they receive my diffs they can get the job done (3 days) and have them back to my door for $1525.

Not thrilled with having to ship them off and have the truck down for an extended period of time, but the local shops here in Tulsa don't seem too confidence inspiring.

Anybody aware of an orginization that might have an exchange/core type setup to offer?

Other suggestions welcome as well:bang:
 
If you are going to send them out, consider sending to Slee. You can have the confidence he will do it right, which I mean to say, do it with OEM Toyota shims.
I'm sorry I forgot the specifics but there is a setup using a "domestic truck" type of shimming and a different method using OEM Toyota shims.
That is the tricky part with the factory lockers.

If you can't find someone familiar with it locally, bite the bullet and send them out. Desertdude sent his off to Slee and had quick turnaround with excellent results.
Maybe it's my unfamiliarity with diffs but I think this is where a few dollars count far less than experienced hands on the job.
 
I found a guy locally who had the tools to do it. I ended up ordering everything from JustDifferentals.com and doing it myself. There is nothing unusual about the 3rds being Lexus or locked. If they can do a Toyota pickup 4x4, they can do these. They are basically the same.
 
I send my to ZUK, and he did a great job. He is the master when it comes to toyota diffs.

Toyota Gear Installs
 
I've done a few locked rear thirds now and can tell you there is a difference if you want it done per the manual.

The carrier is shimmed with Toyota specific shims. Toyota only wants a single shim on either side of the carrier. Those shims need to not only set preload but also backlash.

So in the end only two specific shims will get the job done correctly.

JT sold me a carrier shim set and they were for some other application and went right in the trash barrel.

Doing it correctly is a real PITA and can take quite a bit of time.

FWIW, the rear open is not this way at all and is much easier to setup.
 
I found a guy locally who had the tools to do it. I ended up ordering everything from JustDifferentals.com and doing it myself. There is nothing unusual about the 3rds being Lexus or locked. If they can do a Toyota pickup 4x4, they can do these. They are basically the same.

Exactly. I have geared a locked Toyota 8" myself for a front application on the old SAS 4runner. It was done seat of the pants, (ie-no adjustment tools), but that setup had manual hubs and was only used off road. The 80 is used as a daily driver so want to eliminate all variables.

What "special tools" are needed if I decided to attempt this one on my own?
 
Back
Top Bottom