Freaking Oil pan removal

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 11, 2002
Threads
131
Messages
950
Location
twin cities
Read many threads

This damn thing.

Any sage advice before I bust out the air chisel

It seems access to the lip is also a challenge

Fj40. 1980

Thanks


...via IH8MUD app
 
Easy peasy. Leave a few bolts in it, just in a thread or two (to keep it from dropping when free), and put a little pressure on the side of the pan (near the bottom) with a bottle jack and some lumber. Don't over-do it. Just put a little pressure on it and let it sit that way. It'll give before long. Applying some heat to the gasket area with a heat gun helps to soften the old cork.
 
Did you remove the oil pan bolts? ;-) But seriously I've heard that you can set up a jack between the frame and the pan to force it off. I would only do this if I was replacing the pan.

I've done almost everything myself on my vehicle. There were only two things that I "outsourced". One was my caster shims and the other was replacing the oil pan. In both cases, the garage told me that it took 2-3x as long to do the job as they quoted me and they lost money on the job. It can be a bi**h.
 
I'll give it a go!!!

Thanks


...via IH8MUD app
 
Easy peasy. Leave a few bolts in it, just in a thread or two (to keep it from dropping when free), and put a little pressure on the side of the pan (near the bottom) with a bottle jack and some lumber. Don't over-do it. Just put a little pressure on it and let it sit that way. It'll give before long. Applying some heat to the gasket area with a heat gun helps to soften the old cork.

Did this on my FJ62. I didn't leave the bolts attached but used the jack. I put pressure on the side of the pan with a jack and let it sit, I came back 10 min later and added more. Left and a short while later heard the pop and bang from it dropping. Just take your time and slowly add pressure heat.
 
toward the end of my build thread, i have a pretty detailed description to getting it off without power/air tools. it was hell for a little bit. short story is scrape out a small are of the gasket with a razor blade, big enough to beat a large prybar into. you will probably need to do this twice on one of the long sides. it will pop once you get it started, you just have to get it started
 
I'll let you fells know how it goes

Thanks


...via IH8MUD app
 
Yep,
bottle jack between the pan and the spring hanger. A bit of pressure and go do something else 'til you hear a "BANG!"
Don't overdo the pressure; if you start to dent the pan, back off a bit.
 
Off it came

Small dent but shouldn't be an issue


...via IH8MUD app
 
Strong narrow thin putty knife between cork gasket and block. Tap it in, then it's just like unzipping a zipper. 2x on leaving a few bolts in to catch falling pan.

I have a write up.

http://www.ih8mud.com/tech/oilpan.php
 
I haven't fully committed to pulling the pan, but are ya'll describing this with the engine removed or installed in the vehicle?
Intsalled in vehicle.
 
Installed
 
3/8 chisel will help A LOT. Its the perfect size for the width of the flange to get the hard as a rock gasket off
 
Back
Top Bottom