Flywheel Crack...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 22, 2015
Threads
4
Messages
13
Location
Wyoming/Georgia
Swapping out the clutch on my '83 FJ60 and when I got the flywheel resurfaced this crack showed up:
IMG_4839.JPG

IMG_5227.JPG


You can see it at 12:00 on the top full picture. It was visible before resurfacing, but it is obviously deep enough that the resurface did not erase it.

210K on the car, BTW

Is this crack detrimental? I have even mounted it trying to convince myself it's fine.... given the track record of these vehicles.... Thanks for the input
 
No expert here...but...we know it’s not going to get better, only going to get worse, and it pretty close to the edge now.

That’s my untrained thoughts.
 
Sorry , I disagree. that crack could not be further from either edge. I don't actually see any issues running that flywheel. You could always take it back and show them, maybe get them to take another pass off of it. See if it goes away.
 
Ok, I’m convinced.🎯
 
Weird, must be a manufacturing defect since it isn't a fatigue crack being in the middle like that. You can see two others beside it. If you really wanted to you could gouge it out then fill up with weld then machine flat again. But might as well just drive it till it breaks.
 
Mine had cracks. MAFs machinist said it was normal. Don't rev to 7 K :p

This is your flywheel on crack
 
Last edited:
Thanks for the replies. I'm going to lay off of the burnouts, reinstall the wheel on blind faith, and drive to the coast. If it breaks apart it will make for a great follow-up thread.
 
If it was a real worry you could drill each and to remove the stress concentration but likely not an issue as these are slow spinning flywheels. If it was seeing 6-8 grand on the tach in racing conditions it would be a different story.
 
Yeppers, they commonly look like that. NBD
 
Back
Top Bottom