Flames!!!!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 18, 2005
Threads
14
Messages
58
Location
Orlando, Fl
um, well, we have flames comming out of our carb, heres our issues


1: we got the spark plugs back in order, the #2 and #4 cylinder cables were swapped.
2: we.... have no idea why flames are shooting out of the carb. there are vacume lines coming from the diaphram of the carb, it is connected to the base of the carb. and theres a pluged up vacume on the diaphram of the dizzy.
does this sound right? if not? how should it be?
if it is right, what else could be causeing THREE FOOT FLAMES?

the carb is still not adjusted right because we cant get it to idle.

Ryan // BigBlue, Jonathan // SandRider
 
Your timing might be off causing the spark plugs to fire when the intake valve is still open which in turn would cause a flame to come out of the carb. Check your timing to make sure it is set right. If it is not idleing then it is most likely timing or ignition problems.
 
I thought the painted flames myself.

Check the timing again, sounds like it is off. Try doing a static time on the number 1 cylinder. line up the TDC mark on the flywheel with the number 1 cylinder in compression. pull the number one plug. (check you rotor and make sure it is firing at the number one cylinder) reattach the wire to the plug, with the ignition in the on position rotate the distibutor until the spark plug sparks. tighten the distibutor so that you can still move it and it does not move on its' own reinstall plug and restart.
If you still have fire check back with the board. that is what it is here for.
 
3ft flames ?......... cool
remove the hood and drive around to show off
oh and take some pictures
 
Ultima RB: (retard = anti clockwise)

I'm pretty sure that turning the distributor anti-clockwise will cause ignition advance (at least it does on my '75 2F). Unless it's like the water swirling down the bathtub drain--spins in opposite directions in the northern and southern hemispheres.

Anyway, the most likely cause of flames coming out the carb is that at least one spark plug is firing when its corresponding intake valve is open.
 
I will definatly try out the timing...as thats probably what it is...but I'm nervous to start just turning it around because it IS such an important aspect to an engine...petescoffee do you think that is a reasonable way to adjust the timing?

Also how would I check the ignition out to see if there was a problem?
 
I just did a search and got mixed results about clockwise/anti, sorry about that.
Just keep turning it till it starts.

If you've got flames then I don't think the ignition system is failing as it's got to be sparking. Just not at the right time. You can ground a sparkplug on the block and visually look for spark.
 
we havent re,oved and replaced the dizzy, but theres a chance that the prior owner did so and put it in wrong....... how would ou find out if its in the right way?

Jonathan // SandRider
 
Back
Top Bottom