FJ80 Dirty Valves

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 9, 2026
Threads
8
Messages
57
Location
United States
Is this abnormally dirty for a 3FE engine with 80k miles on it? Any advice on cleaning it up? Going to adjust my valves. Having some white smoke on startup

Was going to break it up with a nylon brush but I don’t know of anything I can spray or should even loosen it? Been running seafoam and frequent oil changes

Also, anyone have the valve adjustment page handy from the FSM?

IMG_9703.webp
 
Is this abnormally dirty for a 3FE engine with 80k miles on it?
Yes

there are alot of ways to try and clean it up although they all have some risk. engine flush products, diesel fuel and automatic transmission fluid all work, BG engine flush is probably the best. But it will take alot to cut though all that sludge. bush at your own risk it will speed up the process for sure but a big chunk falling down into the motor could cause an issue. i see alot of oil changes in your future.
 
Yes

there are alot of ways to try and clean it up although they all have some risk. engine flush products, diesel fuel and automatic transmission fluid all work, BG engine flush is probably the best. But it will take alot to cut though all that sludge. bush at your own risk it will speed up the process for sure but a big chunk falling down into the motor could cause an issue. i see alot of oil changes in your future.
I ran ATF for 100 miles. Hate to say this is better than before. PO had a shop put in this engine with 70k right before I bought it. Looks like they never even cracked it open before swapping
 
Diesel engine oil has a stronger detergent package than oil rated only for gas engines. Over time it might clean that up. Many members here run diesel engine oil. I run 15W-40, usually Chevron or Mobil Delvac. These are not pure synthetic.
 
Last edited:
depending on your mechanical ability / confidence have a look at this thread
 
depending on your mechanical ability / confidence have a look at this thread
Yeah maybe it’s not worth it. I am very capable I believe but I’m gauging opinion on if it’s a big deal or not in this state
 
Yeah maybe it’s not worth it. I am very capable I believe but I’m gauging opinion on if it’s a big deal or not in this state
the last one i had apart for a rebuild WAS clogged. and it looked better then what you have. Valvoline premium blue is rated for both gas and diesel engines, might be a good way to go. i only use the flush products or atf at idle as they dont lube a loaded engine as good as oil.
 
I have yet to run it myself and usually steer clear of hype, but Valvoline Restore & Protect has some proven real-world results. Formulated for cleaning ring deposits, but exceptional results as an engine oil alone with no additives. I'd give it a go althought only available in 5W-30
 
Diesel engine oil has a stronger detergent package than oil rated only for gas engines. Over time it might clean that up. Many members here run diesel engine oil. I run 15W-40, usually Chevron or Mobil Delvac. These are pure synthetic.
^^^This^^^ and some patience. Chevron Delo XSP 400 15w-40 is what I have been running in an engine not nearly this bad. After 2,000 miles what came out looked worse than Mobile 1 at 5,000 miles.
 
Definitely chack that the PCV system is working.

Second or third vote for Chevron Delo XSP 400, it does turn dark quicker than most everything else I've run, likely because it's cleaning and holding/suspending more varnish/carbon/soot than some other engine oils.

FWIW
 
Last edited:
Is this abnormally dirty for a 3FE engine with 80k miles on it? Any advice on cleaning it up? Going to adjust my valves. Having some white smoke on startup

Was going to break it up with a nylon brush but I don’t know of anything I can spray or should even loosen it? Been running seafoam and frequent oil changes

Also, anyone have the valve adjustment page handy from the FSM?

View attachment 4215914

Are you using a non-detergent motor oil? You have to be careful using products that clean the inside of the engines, they break chunks loose which can plug oil passages causing seizing of engine parts. I would use a motor oil high in detergent such as Mobile 1 to clean the engine and it will take some miles. I had a Toyota GTS where the previous owner used non-detergent and using Mobile 1 it took about 50,000 miles before I stopped seeing, brown, white, and other colors in the oil when it finally looked like used motor oil. I change oil every 15,000 miles, filter every 5,000 miles and sold the car with 450,000 miles on the original engine, no rebuild and it still ran well.
 
I have yet to run it myself and usually steer clear of hype, but Valvoline Restore & Protect has some proven real-world results. Formulated for cleaning ring deposits, but exceptional results as an engine oil alone with no additives. I'd give it a go althought only available in 5W-30
i like this oil, i keep it in stock and it does work on newer engines with low tension ring issues. as far as under the valve cover cleaning performance i haven't noticed alot of cleaning in the regaurd. i would bet diesel oil would clean better. but taking the rocker shaft off the engine and scrubbing would speed up the process alot as well as scrubbing the inside of the valve cover.
 
i like this oil, i keep it in stock and it does work on newer engines with low tension ring issues. as far as under the valve cover cleaning performance i haven't noticed alot of cleaning in the regaurd. i would bet diesel oil would clean better. but taking the rocker shaft off the engine and scrubbing would speed up the process alot as well as scrubbing the inside of the valve cover.
Agree on physical cleaning. Regarding r&p, have been lots of top end results that I’ve seen on bobistheoilguy, but of course results vary motor to motor & driving habits. While it’s formulated to clean rings, lots of people report the oil coming out in a red/varnish color, it’s great at cleaning hardened varnish & sludge.

I too have ran Rotella & Delo with great results in my 80 though a 1FZ.

 
This is a perfect candidate for Valvoline restore and protect 5W30. Best additive package going right now for gasoline motors. Diesel oil is fine, but chemistry is different.

Change that oil filter lots... dont let it get restricted when all the crud lets loose.

Check out the motor oil geek on YouTube. And project farm.
 
Back
Top Bottom