Fender Flares 1995

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 23, 2016
Threads
10
Messages
53
Location
oconomowoc wisconsin
Just bought one a few weeks ago. The only thing I do not like is the fact that he took off the flares. I want to keep the 33s on it and would like the flares to look as close to OEM as possible. Any suggestions as far as brand etc?
 
just find some in the parting out section or make a wanted thread on here. aftermarket flares start at 500 and go up from there but used factory ones are cheap.
 
I'm a fan of the flare look. That said, one of mine is hanging by very little and needs replaced. I plan to just replace as needed. The 93-94 flares are fiberglass, 95 not sure, and 96-97 are something like ABS or urethane material. They really aren't all that durable but it just depends on what you run them in to. There are some aftermarket options. MUD member @jamisobe sells pocket screw type flares that have good reviews.
 
Trying to repair the later type flare has proven futile thus far. 2 part epoxies have been a waste of my time. I just purchased some 3m Scotchweld dp8005 bonding material and have the stupid expensive gun for it. Haven't tried it yet though.
 
Thanks folks!!! I was looking for this kind of advice. I did not know if trying to stick OEM or getting aftermarket was the way to go. Sounds like I might take a little longer to decide if I even want to leave it. May have to take decoco's advice. Thanks again.
 
Back
Top Bottom