Factory Hand Throttle Grommet - Photo request

[mattressking]

Can anyone take an up-close front/back photo of a factory hand throttle grommet? Since it is NLA, I need to use a square grommet and curious how close I can get one to match the original.

Here's an example of what I want to see (front and back). My assumption is that it is a normal press-in screw grommet I can notch.

Thanks!

 

[MOTOV8R]

These are the best shots I have. Don’t have this fj45 anymore.

 

[mattressking]

Honestly that is probably good enough! I'll just stick with a screw grommet and notch! I was mainly curious if Toyota put a half-moon for the throttle cable ferrule on the opposing side.

 

[cruisermatt]

My 78 45 has the setup all there - remind me tomorrow and I’ll post a pic here

 

[Living in the Past]

I have a couple loose setups from Australia if you end up still needing a picture.

 

[mattressking]

Good news, body grommets from 80s Toyotas are a perfect replacement for the NLA grommet. Thanks guys

I’m still curious to see if the opposing side is any different @cruisermatt @Living in the Past