Engine running rough

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 18, 2006
Threads
15
Messages
63
My LC runs rough, not always, maybe 10% of the time. Not so much at speeds over 60, but any other time, and usually only for a few seconds to a minute or so. The problem seems to be getting worse, enough so I’m leery of taking any long trips until I get the problem resolved. Could this be a fuel injector problem?
’93 FZJ80 1FZ-FE engine with137k. I’ve had the LC 4 months and driven 4000 miles.
Done some pm work (fluids, etc) as well as the following:

Replace large hose between air filter and throttle body
Remove and clean throttle body
Replace pcv valve
Change spark plugs (even tho old ones still looked good)
Replace gas filter in tank (filter by engine looks new)
Air filter looks new
Wires and dist cap look new

Any suggestions would be much appreciated.
 
My LC runs rough, not always, maybe 10% of the time. Not so much at speeds over 60, but any other time, and usually only for a few seconds to a minute or so. The problem seems to be getting worse, enough so I’m leery of taking any long trips until I get the problem resolved. Could this be a fuel injector problem?
’93 FZJ80 1FZ-FE engine with137k. I’ve had the LC 4 months and driven 4000 miles.
Done some pm work (fluids, etc) as well as the following:

Replace large hose between air filter and throttle body
Remove and clean throttle body
Replace pcv valve
Change spark plugs (even tho old ones still looked good)
Replace gas filter in tank (filter by engine looks new)
Air filter looks new
Wires and dist cap look new

Any suggestions would be much appreciated.

If they are OEM wires, they have the date imprinted on them. If they are original, I would replace them as well as dist cap/rotor.
 
I don't know if those are Toyota wires or aftermarket. If not Toyota OEM wires then replace them regardless of how they "look."

Have you inspected the engine wiring harness that goes next to the EGR valve?

-B-
 
Have you checked your hoses for a vacuum leak?
 
Thanks Beowulf and Romer. I'll get a set of plug wires with my next order to cdan. I'll also do a search on vacuum leaks.
I just found a thread from a few days ago that sounds like a similar problem.
3FE Stumble/Hesitation https://forum.ih8mud.com/showthread.php?t=130209

I found this on that thread:

"And have you blown any EFI relays? Have you upgraded the magic wire in your fuse block? hmmmm?"

As a matter of fact, I had a blown EFI 15 amp fuse a few weeks ago. So I need to search for 'magic wire'.

And I also need to look up "wiring harness that goes next to the EGR valve"

So I've got some things to check now...
 
You have the 1FZ-FE engine, not the 3FE. I didn't read the thread in the link you posted but typically, you should troubleshoot knowing the problem was with the 1FZ-FE.

Blown EFI fuse is an important fact that we needed to know. On your '93 there is a wiring harness to the O2 sensor that can get damaged causing the O2 sensor to report bad info to the ECM which could cause rough running. Several have reported this wire causing a short and blowing the EFI fuse. The problem area is on the control arm (underneath the truck) close to the exhaust pipe and O2 sensor.

-B-
 
Back
Top Bottom