Engine harness clip ID help

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 11, 2006
Threads
207
Messages
1,936
Need help identifying these two clips. Both have numbers stamped on the. One has 25, the other 13.
Both came out of the engine compartment.

any ideas on specific location and part numbers?

B9BCC853-E428-41C4-81D1-27F915C0B196.webp


5C22FE61-531F-4212-BB48-4C930F2E8470.webp
 
I know what they are, my question is where do they go and what are the part numbers.
 
When they break I replace them with an aviation style clamp that will never fail or I use a zip tie. WDG clamps like this MS21919 DG / WDG CLAMPS from Aircraft Spruce Canada
I have access to them as it’s my trade, but as you can see they are inexpensive. Only hassle is the hole is 3/16 so you have to enlarge it a bit.
 
The one with the 13 on it looks like the clip for the starter cable. There is a small bracket bolted to the side of the block straight down under the intake manifold where a clip like that holds the positive cable.
 
The one with the 13 on it looks like the clip for the starter cable. There is a small bracket bolted to the side of the block straight down under the intake manifold where a clip like that holds the positive cable.
Ahh that makes sense now that you say that since was in there messing with that not too long ago.

Onur thanks for your help as always.
 
I believe the one that is numbered 13 is 87616-22010. BUT its not Ordered and it is not. Trying another one. Will post up the result.
Screen Shot 2020-03-24 at 6.47.21 PM.png
 
Last edited:
When they break I replace them with an aviation style clamp that will never fail
Their trade name is Adel clamps, i use them all the time, below is another link to another supplier of those clamps, that stocks a very wide selection of those clamps.
 
Yup, a lot of techs call them wdg as that is the first designator in their p/n. Sometimes I call them adel, sometimes I call them wdg.
Seeing were are talking about them I am curious if you own a pair of the pliers for them? I have heard there is are special pliers for them but all I have seen is a modified pair of vice grips.
 
@fjbj40, I'm sorry to report i have no special pliers for use on Adel clamps. I just install, and remove them the old fashion way when I'm working on electronics, cars or aircraft.
 
Seeing were are talking about them I am curious if you own a pair of the pliers for them? I have heard there is are special pliers for them but all I have seen is a modified pair of vice grips.
Since you ask, and i had no answer for you before, i happen to come across this tool today. It's called a handee clamp, looks like it could be handy to have in your tool box. Below is a link to the company that makes them along with a few photos of the tool being used.
1586715601724.png

1586715623559.png

1586715683312.png
 
Last edited:
so the clamp numbered 25 goes on the firewall but also on the harness at the EGR valve. There is a stand there that the clip fits to and holds the harness.
 
Last edited:
Back
Top Bottom