Ebrake diagram

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 26, 2011
Threads
41
Messages
352
Location
Houston, TX
Hello fellow 80-heads, so my ebrake lever looks like it frozen from rust and it needs to be replaced. I am not sure what else requires attention, since i haven't removed the rotor yet. I checked out another good thread regarding this job which i will refer to. However, i would like to have the diagram w/part #s if thats possible so i can order the parts. Anyone have it?

Thanks!!:D:D
 
Sorry, but i am going to keep bringing this TTT. I only have the drum brake version of the chassis manual. Anyone?? SOS!!!
 
It helps to give us information about what year rig you are talking about.
1997LC_EBRAKE.webp
 
Hi Beno thank you Sir. I will make sure to state the year next time.

The diagram you posted if i compared correctly looks to be for the disc rears (using this thread to compare)

Do you guys sell any kits for the repair? With or without the shoe assy?

Thanks again!!:bounce::bounce:
 
Correct. For rear discs.

We do not have a repair kit per se. Every single part in there is an individual part and priced individually...even the shoes.

I do not know how much it would cost to rebuild, fully, both sides...probably around $500 if I had to guess.
 
Having gone through this with my rig a few weeks ago, I suggest pulling the rotors, remove the entire e-brake system on both sides and just order whatever is seized or breaks upon removal :meh:

I had eyeballed mine and ordered a bunch of parts that took over a week, then when I started tearing down, I snapped a couple of bolts and all of my horseshoe pins were seized up :bang:

Had to cut the pins off and wait another week for more parts (quite a few of them were on backorder) :doh:

No need to replace everything, only what's needed....
 
I plan on pulling my rear wheel today to investigate and photo the problematic parts related to this as well. CDan said this sort of thing is made up of 30 or so parts. I am going to pull one wheel then order double of whatever I see I need.
 
Yea, i haven't got a chance to pull off the rotor yet, high heat = low morale, :D, but i did notice the boot to the lever is cracked &n't mush soft anymore. The lever is frozen bad, so the angle grinder will be called upon. I just hope the springs, other levers, and even the shoes in the hub assy can be reused. I took some pics will post later. Good luck fellas. :popcorn:

Than diagram helps alot, thanks again Beno. Btw, i liked your previous avator better, even though i don't know who it was. :eek:
 
I have a FF in the garage that I am in the middle of rebuilding for a swap into my 91, and I downloaded the electronic FSM off of MUD and have been using it.

Maybe this will help you, never mind, went to copy the link to the FSM and looks like you found it.

Good luck and keep us posted.

Oh, and beno I wish I could get a "Toyota EPC......" Tab on the bottom of my screen;p
 
Back
Top Bottom