eBay snorkel

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Have not seen anyone have problems with hanging front vent lines over brake booster and rears run up near OEM jack mount . Why go to all the extra work?
 
Every time a valet asks me if I've been in water deep enough to need that (and they point to the snorkel) I say "hell no, it's for dust".


Is that what's the dorkels are for? I thought it was only for the chicks.
 
Has anyone ran there breathers to the top of the snorkel?

Someone tapped them into the air cleaner assembly. If your snorkel works, that should be good enough, right?
 
Snorkels arriving on Thursday. How long did it take you guys to install yours?

Cut the air inlet nipple on the Chinari snorkel and then some 3m two sided tape on back of the snorkel eyeball it and press on to fender. You'll be done in 15 minutes and have almost as much benefit as those that cut holes in the fender, same cool factor too.
:worms:
 
Cut the air inlet nipple on the Chinari snorkel and then some 3m two sided tape on back of the snorkel eyeball it and press on to fender. You'll be done in 15 minutes and have almost as much benefit as those that cut holes in the fender, same cool factor too.
:worms:

Wait. You're saying to use double sided tape instead of bolting it on? I already have everything on and ready to go just cannot each the back two screws. Otherwise it's read to go. It's just a little to lose in the back for my liking
 
Wait. You're saying to use double sided tape instead of bolting it on? I already have everything on and ready to go just cannot each the back two screws. Otherwise it's read to go. It's just a little to lose in the back for my liking
Woooosh! :lol:
 
now if he used 700mph tape it would be fine......:popcorn:
 

Users who are viewing this thread

Back
Top Bottom