Does this mean a new steering knuckle?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Beej

GOLD Star
Joined
Apr 13, 2016
Threads
150
Messages
992
Location
Phoenix, AZ
Hey folks,

The threads are stripped on the steering knuckle where the front brake caliper bolts up. It's serviceable but obviously not good. Is there a safe way to deal with this without replacing the whole knuckle?

Thanks in advance for any replies.

-- Beej
 
As cheap as I can sell you a used knuckle (50 bucks) and as important as it is.......

I have heard others tap this to then next bigger size threat, but then you might have to ream out the caliper side; however, what he said.... I would not mess with this.
 
As cheap as I can sell you a used knuckle (50 bucks) and as important as it is.......
Slow, this knuckle got any bearings remaining in it? I'll take it either way but would love it if bearing were still in good shape since mine were new...
 
Slow, this knuckle got any bearings remaining in it? I'll take it either way but would love it if bearing were still in good shape since mine were new...

You can still take your bearings out of your old one.
 
ok, let me give an honest opinion here and dont hate me but...

you gotta tear one side basically all the way down so you might as well spend a few more bucks to get a knuckle rebuild kit from Kurt and do both sides. i know that sucks but since you are already there why not? yes its messy, yes it takes time, yes it cost more but in 6 months when its leaking like crazy you will wish you had just done it.
 
Put Keenserts in the holes. (they're kinda like a helicoil, but stronger)

Have done several with heli-coil and still working well. To be successful they need to be installed with precision, the hole straight, not wallowed, best done in a drill press. That said, if available, would choose a different knuckle.
 
ok, let me give an honest opinion here and dont hate me but...

you gotta tear one side basically all the way down so you might as well spend a few more bucks to get a knuckle rebuild kit from Kurt and do both sides. i know that sucks but since you are already there why not? yes its messy, yes it takes time, yes it cost more but in 6 months when its leaking like crazy you will wish you had just done it.
You are right. Also, I already rebuilt the front axle 18 months ago; got all the bells and whistles from Beno (hence the new bearings). The inner axle seal did fail on this side though and it is leaking so I get to replace that and will have to dig out the gear oil from the birf and regrease. The only good thing about this job is that I don't have to do the other side. Lol:flipoff2:
 
Back
Top Bottom