Desmog question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 5, 2004
Threads
183
Messages
2,217
Location
Reno NV
I'm removing the old exhaust manifold and installing headers...
15922568974036347198448534850506.webp

IMG_20200615_142847.webp

So the intake manifold has that blank space below it that would bolt up to the exhaust manifold. So what I thought I read and saw the answer to capping this off was this plate I got from SOR...
IMG_20200615_142824.webp

My question, is that correct, and if so how do I bolt it up to the intake manifold, with existing studs and nuts and bolts?
 
That is more of a block-off plate for the factory exhaust manifold to keep the intake intact. For it to deal with a crack in the intake manifold, it should have greater thickness, otherwise it isn't needed.
 
you have 2 options, don't do anything and leave it as is, no harm will come of it
you could get a fluid heat riser and run coolant to a plate that is bolted there, it helps on cold morning start ups. depends on what temps you get in the winter.

the great thermo nuclear reactor exhaust manifold

is the intake cracked at all?
 
yeah i would clean and inspect for any cracks, then assuming its fine, let as is, besides removing those studs.
 
@3_puppies I'd totally think about installing this without the water, because both of mine are cracked, and one is cracked thru the weld. No vac leak, running headers, but I plan on buying some thick 'tooling' or cast aluminum plate and fabricating a plate with no pipe fittings, so I don't have to cap them like the Man-A-Fre one.
 
I'm removing the old exhaust manifold and installing headers...
View attachment 2341030
View attachment 2341032
So the intake manifold has that blank space below it that would bolt up to the exhaust manifold. So what I thought I read and saw the answer to capping this off was this plate I got from SOR...
View attachment 2341031
My question, is that correct, and if so how do I bolt it up to the intake manifold, with existing studs and nuts and bolts?
Where did you get the headers from? Cost?
 
Back
Top Bottom