DC Shaft Torque Help

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 27, 2007
Threads
35
Messages
249
People,

I cannot figure this out for the life of me. I know the FSM says 54 ft lbs of torque. The problem is I can't get anything around or on the transfer case side nuts to tighten them down let alone a torque wrench. There isn't any room behind the D/C joint. I can barely get a 14mm wrench on them.

Any help or tips would be appreciated.
 
Don't sweat it. Make them tight, check them before a trip. It will be fine. You won't fit a torque wrench in there.
 
I imagine you could use the fish scale method on an open end wrench if it really bothered you. I just tightened mine as tight as I could with a standard length open end wrench.
 
Thank you all for your input. Just wanted to update the thread for anyone that may encounter this issue. Disconnected the diff side of the shaft to get a better angle at it and still no go. Had "giraffe" come over and take a look at it and still no go.

What I ended up doing was taking "rockrod" "Toyoland66" "bmac1996acc" and other mentioned methods and used blue loctite and got them as tight as I possibly could with an open end.

Thank you all for your help it was much appreciated. Now on to the head gasket . . .
 
Hey Q,

When we spoke on the phone about swapping your 4" lift for my Slee bumper you said you didn't need a DC shaft to run it.

Can you clarify this for me?
 
I bought a Craftsman low profile 14mm swivel/socket I use exclusively for this purpose. Still have to do the 2x lower bolts then turn the shaft 180 degrees. At Sears for about $8.
 
Standard 3/8 socket, swivel, and 8 inch extention gets me in there to do 2 at a time with a torque wrench. Proper torque values insure best fastening results.
IF someone built a custom CV shaft with a monster/way over sized double cardon unit, then access would be compromised....
 
Back
Top Bottom