Cruiser won't start

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 26, 2011
Threads
75
Messages
462
so I had a problem I'm trying to diagnose. A few days ago I drove about 10 miles and shut the cruiser off. I went into the store and 20 minutes later I came back out and it wouldn't start. I started looking through mud and found possible ideas. I checked the fusible link which was good, and is only 2 years old. I checked the grounds on the starter and I also smacked it. All of this did nothing. I remembered hearing something about the fuse block getting too hot so I pulled the cap off the fuse block in the engine bay and both of the silver fuses were very warm still. I left this off and finally about 30 minutes later it just started. The whole time the lights and everything worked fine and my battery had s full charge on it. Did the gear in the starter stick or did something get to hot?? Any help is appreciated!
 
No cranking from the starter. All lights on the dash would turn on though when I turned the key
 
Starter or cable/connections going to or at the starter. Very easy and reasonable to rebuild the starter with new solenoid contacts and plunger.
 
Is it ok to drive for now? Will it start eventually after I let it cool if it happens again or would I be stuck for good?
 
Is it ok to drive for now? Will it start eventually after I let it cool if it happens again or would I be stuck for good?

I can't tell you one way or another. Your call. When that happened with mine it also started after sitting for about 15 or so minutes, and got me home. Next day I yanked the starter. I took it as a sign that my LC was saying that the starter was on it's last legs, and fixed it pronto.

:meh:
 
^^ sound advice! Any advice on which I should do? Rebuild vs new vs reman?
 
Check the switch at the shifter. If I don't firmly put it into park my truck won't crank, a quick bump of the shifter forward and it will crank and start. Its done this since I got the truck back in August, just been too lazy to pull the shifter surround off and adjust it.
 
My starter gremlins turned out to be a fault in the alarm wiring, specifically a rusted relay at the drivers kick panel. The alarm wiring harness connects at the ignition switch plug. You can unplug the alarm harness at the ignition switch temporarily to rule out that system. The alarm wiring is not show in the electrical FSM. Before you change the starter, consider checking for 12v at the smaller starter wire when cranking; and that you have constant 12v at the starter via the larger wire.
 
Ok I purchased a new rebuild kit and am pulling the starter today. Last question, do I need to put anything on the gasket?? Thanks everyone for their help
 
Did I miss something? How did we jump to the starter as the culprit so quickly?

If there was a single click from the starter when you try to crank it then it's definitely the starter being stuck. I'd have someone tap on it with a hammer while you try to crank repeatedly, should free up and start.

If it doesn't click when you try to start the rig ID break out the multi meter before throwing money at it.
 
I missed the part where he said it started 30 mons later. Its not a bad idea to rebuild the starter but this could be as simple as corossion on the terminals.
 
I'd replace the starter in the comfort of your driveway instead of on the side of a trail. Mine left me "stranded" last summer but with a few whacks from a wrench it fired up so I could drive it home for replacement.
 
Well I think I found my culprit. I pulled the starter out and found my contacts were very pitted and in rough shape. I swapped everything out and it fired right up! I started it 4 times with no issues. I am going to go out and drive for a while and see if I get the same results. Thanks everyone!

image.webp
 
Back
Top Bottom