Cracked Transfer Case

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 4, 2005
Threads
12
Messages
176
Location
Northwest
I was putting oil in the Transfer case on my '78 FJ40, and I noticed that it has a crack running down from the area just below where the pto cover plate is it runs down about 1-1/2" it doesn't seem to be in a load area, but I don't really know. is this common for them to crack there? or did someone drop it when they rebuilt it.
 
Not common...


Could have been dropped...


Could have impacted something if ran without or even ran with that tin foil skid plate...


Is it leaking there?


Could it be a mark in the casting?
 
It doesn't look like this does it?

IMG_2699.JPG


If so it's where something came apart in the case and pushed out.

You can do this to fix it.
IMG_2701.JPG


But my concern is if you still have what caused it still floating around. Also I might get a little mirror and a good light and shine in the pto cover and see if you see any marks on the inside. Also putting the trans in neutral and roll the vehical a little and look at the input gear and idler gear for broken teeth.

This is what caused my crack and the inside of the case was scored pretty bad.

IMG_2706.JPG
 
Last edited:
Oil is leaking out of it, it doesn't look like anything hit it there, and it doesn't have the trademark bulge like something got inbetween the gears and the case. It just comes out right at the bottom of the pto cover and runs down. I was planning on running it till it broke then putting something else in, just was kind of wondering if it was common and going to split open all the sudden.
By the way, Skidplate? was there supposed to be a factory skid plate?
We bought this as a v-8 conversion, from what I've learned it was an early advance adapters kit, as it has a plate adapter and cheesy engine mounts.
 
Yes there was a factory piece of stamped steel that was under there, but was probably removed when the engine swap was done...


If you are going to be out using your truck, I would not advise getting too carried away off road with out a decent skid plate...



Good luck!


-Steve
 
FoYoChe said:
I was putting oil in the Transfer case on my '78 FJ40, and I noticed that it has a crack running down from the area just below where the pto cover plate is it runs down about 1-1/2" it doesn't seem to be in a load area, but I don't really know. is this common for them to crack there? or did someone drop it when they rebuilt it.

pics?
 
FoYoChe said:
Oil is leaking out of it, it doesn't look like anything hit it there, and it doesn't have the trademark bulge like something got inbetween the gears and the case. It just comes out right at the bottom of the pto cover and runs down. I was planning on running it till it broke then putting something else in, just was kind of wondering if it was common and going to split open all the sudden.
By the way, Skidplate? was there supposed to be a factory skid plate?
We bought this as a v-8 conversion, from what I've learned it was an early advance adapters kit, as it has a plate adapter and cheesy engine mounts.

I would say fix it or replace it and not suggest "running it till it broke".

Also I just so happen to have a '78 t-case that I took out of mine that I wont be useing. :grinpimp:
 
what were you planning on selling it for?
if I have to take it out of there, I could probably have a friend weld it for me.
 
Back
Top Bottom