Considering an 80-Series

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 19, 2017
Threads
19
Messages
216
Location
Texas
Greetings,

Wandered over here from the 200 section. I’m considering purchasing this 80 series from a friend. 285K single owner. Runs well. Clean inside. Only thing that concerns me is this rust on the lift gate. Will I be able to replace or fix that, or will it be a giant headache?

Also, we have not discussed price yet. What’s a reasonable range?

Thank you!

65DC99E4-9079-4865-9891-ADA6C1A1B8EF.jpeg
 
$1.5k because it has an ARB bullbar. Maybe more if it has a winch?
Pre '93 are generally the least desirable models thanks to terrible fuel economy of a gutless 3FE motor, semi-float rear as well as rear drum brakes. Might be better off replacing the rear hatch if you do go through with it.
 
If rust is that bad on the hatch, it’s probabaly rotted plenty other places also. That’s a run it till it dies type cruiser. Wouldn’t put a penny into it.

Bullbar +Cloth interior is worth 1200 or so. ?

Standing by for the east coast guys to bring the hate.

Nice Avatar. You ever visit Hainon?
 
Last edited:
If rust is that bad on the hatch, it’s probabaly rotted plenty other places also. That’s a run it till it dies type cruiser. Wouldn’t put a penny into it.

Bullbar +Cloth interior is worth 1200 or so. ?

Standing by for the east coast guys to bring the hate.

Nice Avatar. You ever visit Hainon?
That was after my time, but spent many hours on that bird.
 
I'm a bit more optimistic on that truck. I'd do a thorough check for other rusty areas besides the tailgate. If it's confined to the liftgate you should be able to find a replacement easy enough.
The pre-93 models like this one are generally less desirable but some still prefer them. The 3FE motor is underpowered but they're a good motor. If it's been maintained well it should have a bit more life left without too many headaches. The semi-float rear axle is really only an issue if you break an axle. Makes it a more immediate fix if one is broken compared to the full float axles. The drum brakes are also not going to be as good as discs.
All that said, I had a '93 with the semifloat rear axle and it was used hard. Never had an issue with it and I don't feel a huge difference with the disc brakes on my current 80 in terms of brake performance. The discs are better for sure, but the drums aren't so bad that you'll run it off a cliff because you can't stop in time.

Another upside IMO, is the non-viscous-coupler tcase.

I think that truck could be worth $2500-$3000 depending on its history and condition, but the problem issues like the liftgate would be things to haggle the price down. Personally, I'd probably only pay as high as $2000 for it and not more. I'd look elsewhere after that.
 
I'm a bit more optimistic on that truck. I'd do a thorough check for other rusty areas besides the tailgate. If it's confined to the liftgate you should be able to find a replacement easy enough.
The pre-93 models like this one are generally less desirable but some still prefer them. The 3FE motor is underpowered but they're a good motor. If it's been maintained well it should have a bit more life left without too many headaches. The semi-float rear axle is really only an issue if you break an axle. Makes it a more immediate fix if one is broken compared to the full float axles. The drum brakes are also not going to be as good as discs.
All that said, I had a '93 with the semifloat rear axle and it was used hard. Never had an issue with it and I don't feel a huge difference with the disc brakes on my current 80 in terms of brake performance. The discs are better for sure, but the drums aren't so bad that you'll run it off a cliff because you can't stop in time.

Another upside IMO, is the non-viscous-coupler tcase.

I think that truck could be worth $2500-$3000 depending on its history and condition, but the problem issues like the liftgate would be things to haggle the price down. Personally, I'd probably only pay as high as $2000 for it and not more. I'd look elsewhere after that.
Thank you. Great info. If finding a replacement gate isn’t difficult, then I’m much more inclined.
 
Is it locked or not? They make all the difference.
If not, I'd walk away. But that's just me.
 
Is it locked or not? They make all the difference.
If not, I'd walk away. But that's just me.


Depends on his intended use. And you should know its not sporting factory lockers by the year. Mind the internet lore you spread lol

I tend to agree with Adam depending on the details. OP is it lifted? It almost appears to be.
 
Depends on his intended use. And you should know its not sporting factory lockers by the year. Mind the internet lore you spread lol

I tend to agree with Adam depending on the details. OP is it lifted? It almost appears to be.
I don't think the intended purpose matters. A locked vehicle is more capable than a non-locked vehicle. Bar none.
You're right, I'm not thoroughly schooled on the factory options available to specific years, but the lockers could have been added and the poster just didn't mention. Only reason I asked.
Not sure what internet lore you are referring to. Not aware of anything I said that would be considered such.
 
I don't think the intended purpose matters. A locked vehicle is more capable than a non-locked vehicle. Bar none.
You're right, I'm not thoroughly schooled on the factory options available to specific years, but the lockers could have been added and the poster just didn't mention. Only reason I asked.
Not sure what internet lore you are referring to. Not aware of anything I said that would be considered such.
Actually I think intended use does matter. If it's not going to see much offroad use, factory lockers would see almost zero use so "more capable" would be a moot point in that case. Besides, non-locked 80s are surprisingly capable even without lockers. So someone that isn't doing difficult wheeling and is maybe using it as a hunting/camping rig that sees mostly fireroads could easily be satisfied without lockers. I wheeled my '93 for almost 10 years without lockers and we ran a number of difficult trails including several of the more difficult Moab trails. Surprised a lot of people we were with that had lockers.

But as was mentioned, this part of the discussion is irrelevant since the rig in question would not have had factory lockers as an option.
 
If rust is that bad on the hatch, it’s probabaly rotted plenty other places also. That’s a run it till it dies type cruiser. Wouldn’t put a penny into it.

Bullbar +Cloth interior is worth 1200 or so. ?

Standing by for the east coast guys to bring the hate.

Nice Avatar. You ever visit Hainon?

I’d look beyond the hatch rust - those gasket for the glass hold water until you pull/silicone/reinstall on a rehab’d hatch.

If you look, alot of 80’s have a bubble or rust staining from water draining (rainbow effect) - known issue.

————

As a whole, I’d look at the frame & see if you can find out its’ geographical history of life.

As for lockers, anymore unless a creampuff 80 has e-lockers - might just as well either do Harrops or similar, but in the real world I’d want a winch in a open diff 80 over no winch & lockers.
If that ARB is a winch bar, what winch is in it?

As to buying it in general if all above seems solid - how comfortable are you doing your own wrenching or is your wallet padded enough to buy your repairs?

These are getting older so quirks like slow window motors or body grounds corroding are getting common, so if puttering around & baselineing it yourself sounds like a hassle, may not be the exact 80 to buy.

I’m about on the lines as @Box Rocket & his above comments.

If you **can** afford a later (‘95-‘97), more parts are still available & you get some upgrades like the FF rear axle, full OBD2 compliance, etc.

I think they are ‘smarter money’ -unless you want to do a V8 / other powertrain swap, or whatever that gets pretty involved.
 
Depends on his intended use. And you should know its not sporting factory lockers by the year. Mind the internet lore you spread lol

I tend to agree with Adam depending on the details. OP is it lifted? It almost appears to be.
Yes, it has an OME lift.
 
I’d look beyond the hatch rust - those gasket for the glass hold water until you pull/silicone/reinstall on a rehab’d hatch.

If you look, alot of 80’s have a bubble or rust staining from water draining (rainbow effect) - known issue.

————

As a whole, I’d look at the frame & see if you can find out its’ geographical history of life.

As for lockers, anymore unless a creampuff 80 has e-lockers - might just as well either do Harrops or similar, but in the real world I’d want a winch in a open diff 80 over no winch & lockers.
If that ARB is a winch bar, what winch is in it?

As to buying it in general if all above seems solid - how comfortable are you doing your own wrenching or is your wallet padded enough to buy your repairs?

These are getting older so quirks like slow window motors or body grounds corroding are getting common, so if puttering around & baselineing it yourself sounds like a hassle, may not be the exact 80 to buy.

I’m about on the lines as @Box Rocket & his above comments.

If you **can** afford a later (‘95-‘97), more parts are still available & you get some upgrades like the FF rear axle, full OBD2 compliance, etc.

I think they are ‘smarter money’ -unless you want to do a V8 / other powertrain swap, or whatever that gets pretty involved.
No winch on the bumper. I don’t mind doing the work. It’s the time I lack. Thanks for the info!
 
No winch on the bumper. I don’t mind doing the work. It’s the time I lack. Thanks for the info!

If that’s the case regarding your time, then I absolutely would walk. I have many maintenance hours on my rust free 1 owner rig.

That is unless you just want to drive it as is.

I’m in the boat of some of these others guys.

Find a 95-97 clean unlocked version for 8kish, buy, drive and enjoy.

You definitely won’t regret that purchase.
 
$1.5k because it has an ARB bullbar. Maybe more if it has a winch?
Pre '93 are generally the least desirable models thanks to terrible fuel economy of a gutless 3FE motor, semi-float rear as well as rear drum brakes. Might be better off replacing the rear hatch if you do go through with it.
I prefer the 91-92 3FE, and i would do it all over again unless i come across a bargained 95-97
1) The more internet bashed on the 3FE, the cheaper they get due to ignorance.
2) They are very reliable when maintenance is brought up to speed ( its a 25+ yr old rig)
3) fuel economy is bad, but lets' not pretend the 4.5L is getting that much better...I get 10-12 on full armor, 37s..my brothers JK Rubicon gets about 12-14 with similar setup on a 5 yr old design...
4) All FJ80 comes without lockers, adding f/r air lockers or electronic lockers of your choice, no big deal and they tend to be stronger than factory..
5) Bullet proof engine, keep up with maintenance it will outlast the body with no head gasket fuss like the 4.5
6) Cloth seats are much better than cracked leather option in 94+
7) No CDL mod. comes factory
8) Good looking 3 spoke steering wheel
9) for 1/3 of the price of a 1fz-fe, take the money saved and spend them on upgrade and enjoy!
10) iIs a 3FE, and it sounds like a proper off road rig and it purrrs...
 
I don’t mind doing the work. It’s the time I lack.

Sounds like the best 80 you can buy then is one worth cutting checks for maintenance & such.

I’d do a hard pass on any bargain ones, and find a better-than-average ‘95-‘97 model, one worth the back-end investment of labor & parts.

Reason being so you don’t spend ~$2K on a 80 & have $4K in labor/parts if you get a FR axle service & just a few other baseline jobs done out of wallet.
 
If rust is that bad on the hatch, it’s probabaly rotted plenty other places also. That’s a run it till it dies type cruiser. Wouldn’t put a penny into it.

Bullbar +Cloth interior is worth 1200 or so. ?

Standing by for the east coast guys to bring the hate.

Nice Avatar. You ever visit Hainon?

It is always interesting to see the opinions on these vehicles from people who live in rust-free vehicle locales. For those of us in the rest of the US, a little rust doesn't mean run it until it dies or set it on fire.

OP, your question wasn't about what Cruiser you should get, with everyone suggesting later Cruisers. Your question was about this one. If the frame rust isn't bad and it's in good mechanical shape - $2000-$2300 considering it has the lift and ARB bumper. Swap the hatch out for a few hundred and enjoy.
 
I paid $2500 for my rust free 92 this summer. It had 226k miles and needed a water pump, fan clutch, radiator, belts, and hoses right away. Even so it was still a great deal. Straight 6's like the 3FE are my favorites. The way it pulls, sound, and feels like a tractor is quite satisfying. Cruising 60 mph down 2 lane roads in the mountains is a joy and the grunt and torque make for some easy off road work as well. All of my previous 60's series cruisers and 1st gen 4Runners have all been rusty. As long as there's no major under carriage issues I don't really care.

Depending on the rest of the rust situation I would expect to pay $2500 - $3500 here in Colorado. For my taste it would be worth it but we all have our preferences.
 
Back
Top Bottom