Cone washers?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 17, 2005
Threads
31
Messages
169
Location
Where Bugs Shoulda Made a Left...
Are these the dreaded cone washers?

cones.jpg


I've read around and people say to tap on the arm with a hammer, some say to give it a wack, some say lightly tap on the stud with the screw at the top, and some say pry something into the crack and theyll pop out. Whats the verdict on getting these things out? Ive pretty much tried all of the above for about a half hour now and its putting a damper on my disc conversion!

One of the washers doesn't have a crack, it's almost completely sealed, how do I get this bad boy out? Thanks for the help!!
 
a couple of these have worked for me in the past-
hit up on the arm with a brass hammer
hit on the top of the stud with a brass hammer
hit on each side of the arm where the studs are with 2 hammers at the same time
use a small chisel and hit down in the crack of the cone washer.
 
cone washer's

i used some monkey spunk, let it soak for a while and use a punch and gave it a few wack's and they should pop free i had to take one out because of a broken stud and now i can't find a stud or a bolt to put back in....:mad: :mad:
 
ditto 3 puppies and add:
find a socket (impact is best) that is bigger than the washer, put it over the stud and washer, and hit it with a BFH.... a sledge works best because of mass.

took work on the three I've done...
 
Advent said:
I usually use a brass drift and set that on the stud. Then pound it with a hammer. The washer will pop up and you can get it out easy then.



X2:D
 
I just got a 3/4" x 12" brass drift at Harbor freight for $9!!!

sometime Chinese stuff is OK.... :rolleyes:
how do you make a bad brass drift??? :D
(unless the brass isn't good I guess...)
 
I have an old ice pick that I ground kind of flat. I tap it into the split and it kind of spreads them and drives them out. Once it's good and stuck in there, sometimes I have to rock it around a bit. Works as well as anything else I've heard of.
 
I do not like the idea of hitting the stud with anything. Banging on that stud could damage the threads on the stud. Do it enough and the studs will become permantly lose.
Get an old small screw driver you don't want or an old narrow chisel. Grind the end of the chisle down to where the width of the point is flat and the same size as the thickness of the cone washer. Take the chisel and put the point on the crack on cone washer. Whack the chiseld so it wedges the crack open. Do this a couple of times and the cone washers will pop out.
Cone washer removal.webp
 
Back
Top Bottom