clutch problems

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 1, 2006
Threads
24
Messages
106
Location
Brunei
when i try to shift into any gears it wont engage. especially when trying to shift into reverse, it makes this grinding sound.

so i figure its the clutch pump. i found a leak above the clutch pedal n got a repair kit for the clutch master cylinder. ive bled it of all air and tried shifting gears... and guess what, it still wont shift!!! help please....
 
Welcome.



Did this just happen, or has it been acting this way for some time?


Peel the boot back from around the slave cylinder (the piece down on the flywheel housing that you should be bleeding the system from) and see if there is any fluid behind it....if so...it is junk also.


Did you 'rebuild' your master cylinder properly?



Good luck!


-Steve
 
well i just got the car and when i got it the PO said the car was running fine. ive just given it a new paint job n all. now just a few days ago i tried firing it up. and all these problems happen. i kinda got ripped off but im still happy with the car

anyways, i did bleed from the slave.. no fluid leaks visible.. how far is the slave supposed to protrude when the clutch pedal is fully pressed? i think mine went about less than 2inches..
 
its a freakin cruiser not a car!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
 
Slave operation sounds fine....





Clutch disc is stuck to the flywheel...


Put it in low range...start it in gear and stab the throttle a few times with the clutch pedal pushed in...it should pop free...


Good luck!


-Steve
 
i found a leak at the slave cylinder, bought a new one for $25 bucks which would make it about $15 usd.. but that still didnt work..

then i tried poser's method...... that got her workin.. thanks man!

1 more question, how long should i adjust the slave's rod?
 
You adjust it so that you start feeling resistance about an 1inch down from the top and there is no grinding going in to reverse when you are stopped. If it is tight at the top, you shorten it; if it grinds when it is down, you lenghten it.
 
Pin_Head said:
You adjust it so that you start feeling resistance about an 1inch down from the top and there is no grinding going in to reverse when you are stopped. If it is tight at the top, you shorten it; if it grinds when it is down, you lenghten it.
You might want to stay alert to the position of the clutch pedal when you feel the increase in resistance. If either the slave or the master has a marginal seal, then it will slowly allow air into the system and your clutch engagement will slowly require the pedal to be pressed further towards the firewall. It can sneak up on you because it can happen so slowly until you start grinding gears. This can happen without any sign of leakage. You can determine if this is the case by bleeding the fluid and seeing if it you see air bubbles. I highly recommend replacing the bleed valve with one from Speed Bleeder so you can bleed the system yourself and not have to worry about reintroducing air into the line. You can put a clear tube on the bleed valve and run it over to the driver’s side into a clear plastic bottle. That way you can press the clutch down, see what is coming through the tube and watch the level in your master cylinder at the same time. On my 78 the bleed valve is the same size as the front brake caliper M10x1.0 (speed bleeder p/n SB1010). I use them on the clutch and all four calipers. It makes bleeding a very easy job for one person.
 
Back
Top Bottom