clutch fluid low..

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 9, 2005
Threads
26
Messages
82
Location
Decatur, Ga
It was full a week and a half ago, but last night, noticed it was near empty.
What sort of expenses am I looking forward to in the very near future?

Time for a new clutch and pressure plate? Never had a vehicle that I needed to keep an eye on the clutch fluid before.
 
If I need a new slave cylinder....what is the difference between the aftermarket or OEM from CC, besides the $40?
 
IMO, skip the rebuild....every one I've done has died in a month or so anyways....the rebuild kits are nice for a trail fix, but I end up doing it right with a new slave at home.

I ran a CCOT unit with no complaints....but shop around, quite a few vendors (including some great forum sponsors) have these avail too </end pimp> lol
 
droopydawg said:
What sort of expenses am I looking forward to in the very near future?

Time for a new clutch and pressure plate?

This shouldn't effect your clutch disc and pressure plate. I've used the non OEM parts with no probs, but as said above, I'd skip the rebuild.

You sure it's not just the line connection or the line itself? Lines are cheap if it is just that.
 
Here is an idea....fill up your cylinder...have a buddy press on your pedal. Look around where it is leaking. If it's leaking at the bottom of the cylinder where the metal tube connects to you may of had moisture build up in there and it has rust pitted out enough to cause a small leak. This happened to me, not sure why or how it rusted but it was enough to cause a leak. So just buy one of those brass fittings to replace it with. If you look inside the cab up under the dash and there is fluid on the fire wall then your cylinder is gone. Most definately go with a new cylinder...takes all of 5 mins to swap out and 5 more to bleed it.
 
CruisinTiger said:
This happened to me, not sure why or how it rusted but it was enough to cause a leak.


if i'm not mistaken, brake fluid is hydroscopic. meaning if given the time or enviroment, it can pull the moisture out of the air. water being heavier than water, will collect at the lowest spot that being......
 
Back
Top Bottom