Well, slowly working through the baseline on my 95 i bought in Jan with 179K (now at 185K).
I like to do what I can myself when I have the time (2 year old and 6 month old kids).
I bought plugs, wires, cap and rotor from Toyota about a month ago and had not gotten time to do the job, the first time always takes longer until you get to know the rig... I took the advice of my wise (old?) pop, who said: "looks like you'll have to get the shop light out after the kids have gone to bed.
Some newb tips from a newb:
Tip one - Cruisers are tall. I let the air out of the front tires to get the extra 8" or so of extra standing height on the engine compartment - helped immensely when reaching in from front or side of truck.
Tip two - make damn sure you have at least a 6" socket extension, but having a 6" and a 10" both are better. Learned this the hard way with a 9pm Home Depot trip. The 3" extensions in most kits won't even let you scratch your nuts whilst doing the plugs.
Tip three, don't attempt without removing intake and airbox. Just a pain in the bum.
Turns out, the plugs needed changing BAD. (See Pics) Wires, cap and rotor looked ok, but swapped em anyway. Plugs were very worn. Some minor deposits on them (just ran SeaFoam treatment through about 1000 miles ago), but otherwise no engine problems to report after examining the plugs - WHEW!
Old plugs are about 1/2 the thickness and twice the gap on the electrode from new...
Truck now pulls much better off the line, hoping to see some minor gas savings, will report back after first tank.
Pics of old plugs:
Tip
I like to do what I can myself when I have the time (2 year old and 6 month old kids).
I bought plugs, wires, cap and rotor from Toyota about a month ago and had not gotten time to do the job, the first time always takes longer until you get to know the rig... I took the advice of my wise (old?) pop, who said: "looks like you'll have to get the shop light out after the kids have gone to bed.
Some newb tips from a newb:
Tip one - Cruisers are tall. I let the air out of the front tires to get the extra 8" or so of extra standing height on the engine compartment - helped immensely when reaching in from front or side of truck.
Tip two - make damn sure you have at least a 6" socket extension, but having a 6" and a 10" both are better. Learned this the hard way with a 9pm Home Depot trip. The 3" extensions in most kits won't even let you scratch your nuts whilst doing the plugs.
Tip three, don't attempt without removing intake and airbox. Just a pain in the bum.
Turns out, the plugs needed changing BAD. (See Pics) Wires, cap and rotor looked ok, but swapped em anyway. Plugs were very worn. Some minor deposits on them (just ran SeaFoam treatment through about 1000 miles ago), but otherwise no engine problems to report after examining the plugs - WHEW!

Old plugs are about 1/2 the thickness and twice the gap on the electrode from new...
Truck now pulls much better off the line, hoping to see some minor gas savings, will report back after first tank.
Pics of old plugs:
Tip


