Caster Plate Question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Where I have you drill the holes it accomplishes a few things. It corrects caster for lifts in the 4" range, aligns the pinion angle to use a DC shaft correctly, drops the arms slightly to gain more clearance between the arms and the tie rod to avoid contact between the two and rotates the axle on it's center to maintain the axle's original position on the arm to avoid spring contact with the bump stops.
If the pinion is aligned to use a DC shaft correctly, is it also that much less likely that a stock drive shaft will work? If so, LandTank plates may still be an excellent choice for the people who expect to use a DC shaft (which seems pretty common at 4" lift).
 
Yup. With a 4" lift and accelerating, the torque forces the t-case, DS and front diff pinion more "in line". When you decelerate (take your foot off the gas pedal), it puts them in a "relaxed" state which changes the drive angle just enough to cause the vibrations.

Since I did my lift I've helped about ten or so 4" lifts. All of them vibrated before adding the DC DS. I would test out the first few by removing the DS and running without it. Sure enough the vibration upon decel was gone. The DC DS took care of it.
 
Last edited:
If a small percentage of trucks don't get driveline vibes when they add plates (accel or deccel), and most don't get vibes on acceleration, it seems like plates with slightly less adjustment would work without vibes. Does anyone sell plates with caster correction around what you'd get from bushings?

It seems like some people would prefer to keep stock bushings. A plate set that allows people to use stock driveshafts may appeal to some people who have been driving lifted trucks and no caster correction. Is there some downside to a plate like that, that I'm missing? (aside from it perhaps not existing yet)
 
If a small percentage of trucks don't get driveline vibes when they add plates (accel or deccel), and most don't get vibes on acceleration, it seems like plates with slightly less adjustment would work without vibes. Does anyone sell plates with caster correction around what you'd get from bushings?

It seems like some people would prefer to keep stock bushings. A plate set that allows people to use stock driveshafts may appeal to some people who have been driving lifted trucks and no caster correction. Is there some downside to a plate like that, that I'm missing? (aside from it perhaps not existing yet)

Slightly less correction can put you a place where neither drive shaft will work and only drops the amount of caster correction which will adversely effect handling.

So if you want that, press in some bushings
 
Back
Top Bottom