Carb Removal Question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 29, 2003
Threads
283
Messages
2,381
Location
Louisville, KY
OK, before I spend more time on this than I have to, are there any tricks to taking off a stock carb on a smogged 1980 FJ40? I can see the 4 mounting bolts at the base of the carb but it is real tight, but doable. It would seem that you could dismantle in sections. Is this the case? I just looked at it briefly last night on a break from my PS conversion.

Thanks.

JL
 
for the 2 nuts on the valve cover side, if you have a dizzy wrench it makes it much easier but a stubby open end or claw foot can work.

take pics so you can get it all back on right
 
Thank you. I figured there was no way around it. I am thinking about using some hinged sockets at first. I have already taken pics of the engine bay prior to the PS conversion just in case I hit a hose-and there are a lot of hoses at the moment.

Thanks fellows
 
Yes, one of those dizzy wrenches saves hours of frustration. Also be careful of that vacuum fitting in front of the carb on the manifold, those plastic nipples shear off real easily when the wrench slips off the nut. Don't ask me how i know... :doh:

Nial
 
Snap On, $30 12mm, very usefull as a carb tool and a dizzy wrench.

Jukelemon said:
OK. I am clear on the dizzy wrench. Too bad noone around here has one in metric.
 
Thanks Pimp BUT Snap On does not list a 12mm in that wrench??? That is now they do not according to their catalog.
 
Last edited:
PabloCruise said:
I took mine off when I had my valve cover off - mine is a '78 - that got me a little more room....

I have a stubby 12mm for the inboard nuts, but if it feels like they're not gonna cooperate, I will also pull the valve cover off to get the room it takes to put a regular length wrench in there.
 
Back
Top Bottom