Can I drive without the kickdown cable?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 14, 2004
Threads
232
Messages
3,965
Location
Virginia Beach, VA
Hi folks,

My throttle kickdown cable is trashed (sticking) and I will need to drive it like that for a few weeks. A test drive doesn't show much difference from with it disconnected. Will this cause any issues with my transmission? Does the TPS tell the TCM the same thing as the throttle kickdown cable?

Thanks!

Dan
 
Shouldn't be a problem. The cable adjusts system pressure, so shift pressure. With the cable fully retracted it will shift lazy/slip a lot, if the cable was pulled fully out it will shift more firmly, less slip.
 
Shouldn't be a problem. The cable adjusts system pressure, so shift pressure. With the cable fully retracted it will shift lazy/slip a lot, if the cable was pulled fully out it will shift more firmly, less slip.

Really? If that's the case, I'll just pull mine.
 
Really? If that's the case, I'll just pull mine.

You can, but I didn't see any benefit? If removed and held full on, shifting as harsh full time, maybe good for drag racing? In high range it wasn't too bad, in low range, major wheel spin, not the best for technical, trying to be smooth, type wheeling.

The best combo that I found is; adjusting the main pressure regulator in the valve body tighter/higher, then the cable adjusted to fine tune. The main system pressure regulator adjusts the total pressure available. The cable is a progressive regulator, reducing the pressure at lower throttle openings, to better match shift power to throttle/motor power. In my experience, the progressive regulator is a big benefit.
 
I think I'll keep the cable:)

This does make me wonder about a trail fix or fix for the OP's temporary situation. Is it possible to manually spot the cable position to hit a sweet spot in between Harsh Town and Slippage City?

I've not yet needed to adjust or work on the kickdown cable, but just wondering out loud for future reference.
 
Shoot some WD-40 down it.

I tried that and every other lube I had on hand. I spent two hours with it out of the vehicle and made some progress, but it still won't move freely.....
 
I think I'll keep the cable:)

This does make me wonder about a trail fix or fix for the OP's temporary situation. Is it possible to manually spot the cable position to hit a sweet spot in between Harsh Town and Slippage City?

I've not yet needed to adjust or work on the kickdown cable, but just wondering out loud for future reference.

Sure, put it where you like. It will always be a compromise, if most of the way out, low power shifts will be harsh. If most of the way in, higher power shifts will slip more.
 
Kevin,
Thanks, hope I don't need to ever know that, but good to know it.:cheers:
 
Dan
When my 62 throttle cable was sticking I pulled the cable held it vertically
and worked tranny fluid down the cable into the housing, using a plastic syringe.
After filling with as much fluid as I could, I worked the cable back and forth
until it no longer stuck. Not perfect but it did make a great improvement over what i started with.

Good luck
 
I've been driving without one for 2 years now. No issues. But you do need to know how to let off the pedal when it shifts otherwise your RPM jump up.

The "RPM jump up" thing is clutch/band slippage, not good for wear or heat. I would replace the cable or at least adjust the progressive regulator higher, 1/4-1/2 way?
 
The termination stud on the end of my cable fell off at the throttle body. I have temp fixed buy crimping a spade connector on to the cable which is holding it in its bracket. Does anyone know what these termination studs are called? Or where I can pick one up. Thanks
 
Back
Top Bottom