Bleed/flush clutch hydro lines?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 23, 2005
Threads
494
Messages
13,827
Location
Reno, NV
Website
forum.ih8mud.com
:princess: helped me flush my brake lines last weekend. We pupmed brake fluid through the lines until it ran clear at each wheel.
Last night I was looking at the clutch master cylinder and noticed the fluid there is pretty black. So I put a flush on the list.

My question is how often should I do this in the future?
 
The brake fluid changing colors/getting dark to black color is an indicator of the fluid having moisture suspended in it, which is not a good thing.

Series Land Rover folks are advised to bleed their hydraulic systems every year and to use DOT 3 Castrol LMA (low moisture activity) fluid.

When the reservoirs start to get a little dark, I bleed the system until clear fluid flows.



:beer:
 
Poser said:
When the reservoirs start to get a little dark, I bleed the system until clear fluid flows.

Steve - sorry... but to be clear does this just mean pouring new fluid right into the reservoir and just mixing with old and just keep adding and bleeding until the old and mixed are out and it is just flowing clear? You do not mean drain the entire system of old fluid then reintroduce new fluid and bleed right?
 
Poser said:
I clean the old fluid out of the reservoir, wipe the reservoir clean and refill with new fluid then bleed the system.


:beer:
I'm guessing that is easier than priming a dry system?
 
I'm sure Poser, like myself, just removes enough fluid from the resevoir to clean it out and prevent having to send a reservoir full of dirty, moisture ridden fluid through the slave until new clear appears at the bleeder. Just don't remove so much that air enters the system. Obviously, fill the cleaned reservoir with new fluid before flushing/bleeding. The transparency of Toyota plastic reservoirs make this task easier.

I'm also with Poser on regular brake sys flushes, though not because I'm a brake expert like Poser is. I'd say every year just for the moisture factor, let alone solid contaminants (dirt). I think regular flushing prevents moisture and dirt from deteriorating master/slave/wheel cyl piston cups or caliper piston seals sooner than should happen. I'm confident most brake overhauls (not pad/shoe changes) occur due to neglect.

I like the relatively new Dot 4 synthetic fluids that are Dot 3 compatible. I think they absorb less moisture than Dot 3 conventional. They also handle a little more heat, not that it matters for a 4x4. Well, maybe for towing down steep grades with an automatic. :D
 
Back
Top Bottom