Blackstone Test Question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 28, 2003
Threads
37
Messages
279
Location
The Buttcrack of Idaho
I have posted on here a couple different times about my engine sooting problem. I had a brain fart yesterday and wondered if sending in an oil sample to Blackstone would help me isolate the problem.

Any Blackstone experts think this might help.

Jay

Previous post: https://forum.ih8mud.com/showthread.php?t=189112
 
Bump
tdo3.gif
 
No. I think you need to throw it on an exhaust gas analyzer to see what is happening.
 
jaysdead40;
Wondering if you have performed any services, repairs, replacements, tune-up, cleaning,etc; and if so, any changes? idle smooth, acceleration good, puffs of blue smoke, MPG? smell of fresh gasolline when you start? soot, stinky cats still? After all that, you may have to bite the bullet and take it in to a dealer/mechanic who can run some diagnostic testing.

I know, main purpose of the forum is to do it yourself, but sometimes you gotta pay the man. Then you can come back and share the info with all of us. I am sure if you take it in to the dealer they will want to perform just about every service we talked about (for at least $800). You have two options as I see it; do/check everything yourself first, or, when you go to the dealer, just tell them you have already done everything, and all you want is the diagnosis of the soot problem.
 
Thank you for the responses.

On that advice I talked with two different shops today, (one is a cruiser guy) neither shop has an exhaust analyzer, both told me because 93 isn't OBDII they can't pull anything but flash codes, both told me I'm running rich and probably have injector problems.

Next round of advice?

Jay
 
Did they offer any suggestions; like actually checking each injector, pulling the injectors, injector cleaning on or off the vehicle ?? ie: run cleaner through the injectors on the vehicle?

You could try cleaning the injectors yourself if you haven't already (BG44K in the tank, Chevron Techron, Lucas injector lube/cleaner (All at NAPA), but fill up to only about 1/2 tank of gas.

A dealer can run through the proper diagnostic steps to determine if it is one of the injectors or something else entirely. It may be something simple; I would not let them replace all your injectors if that is what they recommend; I would be a bit surprised if any are completely bad and new ones are crazy expensive, not to mention about a days labor to R&R at a dealer.
 
Last edited:
I think it all stems from that rear bumper and tire carrier. :idea:You should tale it off and send it to me for further diagnostics. I wish I could help, but I've got no other ideas.
 
Did they offer any suggestions; like actually checking each injector, pulling the injectors, injector cleaning on or off the vehicle ?? ie: run cleaner through the injectors on the vehicle?

You could try cleaning the injectors yourself if you haven't already (BG44K in the tank, Chevron Techron, Lucas injector lube/cleaner (All at NAPA), but fill up to only about 1/2 tank of gas.

A dealer can run through the proper diagnostic steps to determine if it is one of the injectors or something else entirely. It may be something simple; I would not let them replace all your injectors if that is what they recommend; I would be a bit surprised if any are completely bad and new ones are crazy expensive, not to mention about a days labor to R&R at a dealer.

I was talking with them about diagnostics, I don't trust any of them to work on it.


This might sound like a dumb question, but what kinda gas are you using? (brand/octane)

I usually run SINCLAIR 88 octane.

I think it all stems from that rear bumper and tire carrier. :idea:You should tale it off and send it to me for further diagnostics. I wish I could help, but I've got no other ideas.

You've been thinking in your tree hammock again
flipa.gif
. What happened to your plans to build your own rear bumper, and where we going next year, I need something to look forward to.

The big question is, if I need to get to the injectors, and the EGR, and clean the intake. Is it time to nut up and do the head gasket while it's mostly apart.

Jay
 
I would not pull your engine apart just yet, and definitely not for a bit of soot. Find a Toyota shop (or shop that works on Toyota's) that has a good master mechanic; they are out there. The key is to try talking to them directly when the service writer is not around. One of the service writer's jobs is to run interference between the customer and the mechanic, but also to get as much money out of you as possible.

At this point, assuming you have done all you can, I would take it to a mechanic and be done with it.
 
Back
Top Bottom