Bent frame in rear. Suggestions?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 19, 2004
Threads
18
Messages
123
Location
Colorado
I was trying to figure out why my shakle angles in the rear were different. Then I noticed the frame was bent :(
It must have been rear ended at some point or something. It has been this way for over 15 years ever since my dad bought it. I am pretty sure this is why this shackle is further forward then the other one and the cause of the different shackle angles.

Can this be repaired? Should I just leave it like this an continue to wheel the hell out of it?
It drives straight and it doesnt seem to affect anything. However, the rear spring does get compressed into the mount sometimes.

BTW, these are new springs, shackles, bushings, and shocks.
 
Last edited:
you could try taking it to a frame shop. it might just be out of square or it could have a twist to it as well.

*edit*
did'nt see the second pic....never mind
 
[QUOTE='74 UA FJ]'wheel the hell out of it. Aint gonna hurt nothing. take a sledge and straighten that bump out if it bothers you.[/QUOTE]

Thats what I like to hear! :)
It kind of bothers me that they are not semetrical but I can live with it I guess. I might take a few swings at it with my sledge once I get that old muffler off and can really get a good whack at it.
My only concern is that these are new springs and once they break in, I might have a problem with the spring hitting the mount a lot more when it compresses.
 
Landcruisersteve said:
With that custom mod of yours, you're probably the only one who doesn't have "FJ40 lean." ;)

True, I was wondering why I didnt have the typical lean. Pretty funny. The other side is bent too but not nearly as much. Its a beater so I dont mind. Boy have I put a lot of time and money into this beater. :)
 
Yeah I would run it.....hit it with a sledge and try and straighten it...and if ya like doin mods you could weld a plate over it to "box" it in....just my 2 cents

where did you get the shackles from?

Chuck
 
I jacked the drivers side tire up and noticed that the rear passenger side spring hits the hanger. This problem really prevents the rear from flexing as much as it could. When it hits the hanger, there are still about 6 inches between the axel and the bump stop. I took off the old 2" extended shackles when I put the lift on. I was thinking that I would try putting one of the extended shackles to help with this problem.

Is there any reason why this would be a bad idea? I really dont like the way it is. I have not tried to straighten the frame with a sledge yet.
 
Measure the distance from the center of the front and rear hubs on each side. I expect you'll find a disparity that proves a misalignment of the front and rear axles to each other which will probalby produce uneven tire wear. No matter for a trail only rig, I suppose.

Have it straightened. At least obtain an estimate.
 
Advent said:
That frame bend looks almost exactly like my rig where I once threw a loop of chain around it to pull out a friend. Any other pictures?

What exactly are you looking for that is not in the pictures I posted? I want to make sure I get the right angle shot.
I may get an estimate but I would also like to know about by shackle idea. If I do this, I will have two different length shackles. Any problems with this?
 
Back
Top Bottom