anyone recognize this rear bumper???? (1 Viewer)

[mrsleeve]

As the title says.... Its whats installed on my new to me 96 LX and I am not a fan, I have seen what I am pretty sure is this thing, but I cant seem to find it anywhere (yes I have been searching for a week) or remember the fab shop/branding. I am not likely going to keep it and will prolly put a Labs or a Dissent on in the future but I need to figure out what I have and finish this thing 1st

Thanks guys

Untitled by mrsleeve, on Flickr

 

[tampacruiser95]

Is it straight bolt on? Looks light. Can you take a picture of it from the back, straight on?

 

[mrsleeve]

yes its a bolt on and very light for a HD fabed rear bumper I will this afternoon when I get back over to the shop

 

[tampacruiser95]

Okay thank you.

 

[JunkCrzr89]

Its whats installed on my new to me 96 LX and I am not a fan

I’ll buy it as is if you want to part with it.

 

[mudgudgeon]

My guess is it's a home brew??

 

[heckler]

Almost looks like a Sean's/Houston fab bumper.

80 series swing out tire carrier bumper

main beam is made from 3/16" rectangular steel, everything else at least .120 wall. 3/4" thick clevis mounts that pass through bumper and are welded to the frame brackets, side protection brackets bolt up to existing captured nuts on frame, and those brackets are made of 5/16 and 3/8 steel. i...

forum.ih8mud.com

 

[Shoredreamer]

Maybe @LC4LIFE

It looks cool, if you don’t need a spare tire carrier.

 

[tampacruiser95]

I actually like it. Super basic

 

[mrsleeve]

straight on shot I sorry took me a couple days been busy, @heckler I am leaning to your idea, as I have most of the swing out parts for the the pivots and latches but and the recovery points that were never welded into the bumper or truck so that might be what I have

Untitled by mrsleeve, on Flickr

 

[Heckraiser]

My money's on homemade. Rear cross member has been cut out too, so keep that in mind as you shop for a new bumper.