Anyone know what this is?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 5, 2006
Threads
11
Messages
70
Location
Qualicum Beach, BC
My 94 had a rattling noise that increased with engine RPM for a few minutes...

When I got back home, I found this in the driveway underneath the truck on the passenger side behind the front tire and, magically, the rattling stopped.

anybody know what this is and where it goes? Its appears to be made of stainless steel and is about 3 inches long and 4 inches wide.

IMG_3494.JPG
IMG_3494.JPG

Img_3492.webp
Img_3493.webp
Img_3494.webp
 
Shield for the rear O2 sensor. Should only come off if the O2 sensor comes off. I would go look and see if it is still there.
 
O2 sensors are still there...No CEL...no other noises. Just a fairly clean looking part lying on the driveway! I looked up underneath, and both sensors are in plain sight...no covers.
 
Does look like a heat shield of some sort, something AC related or goes over one of the sensors on the passenger side of the block. (when I did my o2 sensors I didn't see that heat shield covering them)

Look around the exhaust areas for something that doesn't have a cover over it, might go somewhere around the thermostat side, perhaps PAIR covers?
 
It is a heat sheild for the o2 sensor, if sensors are still intact then the sheild was left off on prior sensor removal and left on or around exaust system during removal or was installed on outside of flange instead of under the o2 sensor flange and fell off due to corrosion or not putting 12mm nuts on it.
 
Hmmm...I test fit the little devil, and it does appear to belong there...nuts are still on both O2 sensors. I wonder how long it was loose...Its cold outside, everything appears to be working, so I guess its time for :beer:

thanks all!
 
That is a protective shield for one of the O2 sensors. Somebody did a half-assed job of replacing a sensor and did not put the shield back on.
 
Yeah, a half-A**ed job is about right for most everything the PO did. From the tires to the belts...which reminds me...time to replace those before they bite me...
 
It is the protector for the O2 sensor. My truck made that intermittant rattle, driving or stopped for two weeks last month. No rhyme or reason as to when the rattle occured. It drove me absolutely crazy for two weeks till I found it. The shield had not fallen off but was hanging from one stud on the exhaust flange and hitting the rocker panel, thus the intermittant rattle. The nuts were gone from the o2/exhaust flange studs on mine. It did not blow the o2 sensor out of the pipe though there was nothing holding it on. No CELs either.

I took the opportunity to get new sensors, gaskets and had to retap the threads for the O2 sensor flanges as the threads were basically nonexistant at that point. A wire brush would not clean them up enough. Re-tapping the threads was a pain but everything went back together fine.

I can not believe the nuts were still on the exhaust flange if that had fallen off though? The shield must have never been put back on correctly, maybe it was just laying up on the studs, no nuts?
 
Back
Top Bottom