Ambulance door latch question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 10, 2015
Threads
11
Messages
109
Location
Kansas
Late model top to '64 tub.
I've mounted the doors fairly close, they latch and everything, and before I attempt the weatherstripping install I figured to get the latch right. S.O.R. lists the part as a latchbar, it's what is spring loaded from the door and goes into the actual catch on the body top and bottom. My top one barely engages in the catch, it has more travel available, but seems to sag back into the door, and I'm not sure if it is designed to actually fit better into the catch. I've never seen one up close.
IMG_2912.webp



I would guess I have a tired spring in there if it IS supposed to fully engage, probably stretch it some I guess....
 
Yes your spring is tired but the catch were it is sloppy in your first video is adjustable somewhat. You should be able to move it toward the engine or toward the rear a small amount. Also, once you get fresh weatherstripping it will make it tighter too.
 
Funny timing... I just redid my lower spring yesterday. It was tired as well, and as I would travel off road, the latch would work its way up out of the catch and the bottom of the door would pop loose.

I got a stronger (and a bit longer) spring and it seems to be much better now. I try to get my latches to bottom out so they aren't on the verge of popping open.
 
  • Like
Reactions: NKC
UZJ40, I'm going to first try and stretch the springs, I like the idea of full depth, maybe that will do the trick. What springs did you replace yours with?
I just rebuilt my upper and lower ambulance door latches. Found the right size straight springs at the hardware store. One latch has the original striker and the other one I made a copy of aluminum. I took a #10x32 eye bolt, tapped the threads in to the new and old strikers and voila, even used clothes hanger wire for connectors to the handle. After you install the weatherstrip it should take up a lot of play, but I was thinking that you can get some adjustment from the striker latch on the top cross member and the lower tub by loosening the bolts. My doors came out real tight and have to slam the door hard to seat. I had a little adjustment on the top cross piece but had to drill holes for the bottom new Aqualu tub.
 
I just rebuilt my upper and lower ambulance door latches. Found the right size straight springs at the hardware store. One latch has the original striker and the other one I made a copy of aluminum. I took a #10x32 eye bolt, tapped the threads in to the new and old strikers and voila, even used clothes hanger wire for connectors to the handle. After you install the weatherstrip it should take up a lot of play, but I was thinking that you can get some adjustment from the striker latch on the top cross member and the lower tub by loosening the bolts. My doors came out real tight and have to slam the door hard to seat. I had a little adjustment on the top cross piece but had to drill holes for the bottom new Aqualu tub.
 
One thing I haven’t seen anyone mention is the horseshoe spacer used to bring the striker closer to the catch.
 
Back
Top Bottom