4L problem

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 22, 2013
Threads
6
Messages
47
Location
Kentucky
Went to engage the 4L on my 94 today, CDL light didn't come on nor ABS, and didn't switch into low range. What do I need to look for? Driving in low, felt like it was still in high range by the shift points and mph. Is it not a mechanical linkage when changing to low range? Where do I begin?
 
You need to look for the appropriate Toyota Factory Service manual and also look for the many other threads that contain the answer to your query. With out a proper manual, maintaining and repairing an old car is vastly more difficult. This is the starting point.
 
What? It is a mechanical linkage. Shift trans to neutral then shift the t case lever to low.

Get your fsm at the link in my signature
 
Maybe the linkage got disconnected, I have seen this happen on a few heeps
 
Well, it is shifting into low range, can also hear solenoid clicking but no cdl light or abs light come on, and front and rear lockers won't engage. Looks like I've got an electrical gremlin to chase now. Thanks for the input everyone!
 
Put a jumper into the plug on the harness side for the cdl switch, this should make light on dash light up and abs light up, if this works then wiring to switch is good, and you have a bad switch in the tcase. If the light still does not come on then your wiring is bad. Lockers won’t locknunless it sees the cdl locking
 
Back
Top Bottom