Not to complicate things but there are some oddball '93-'94's with semifloat rears. My old '93 had a semifloat rear end and a local friend with a '94 also has a semifloat rear. Both were original factory setups.
3rd Member Interchangeability?
- Thread starter jaymar
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Hi Linus- my concern was whether or not the installation of a gear and pinion set from an '81 60 series LC
(that has a different gear ratio than my '81 40 series LC) can just be a
bolt on and adjust job. Aside from the number of gear and pinion teeth, are there any differences when you go to a
taller or shorter 3rd member ?
(that has a different gear ratio than my '81 40 series LC) can just be a
bolt on and adjust job. Aside from the number of gear and pinion teeth, are there any differences when you go to a
taller or shorter 3rd member ?