2f mixture adjusting

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 20, 2002
Threads
99
Messages
310
Location
Coeur d’Alene, Idaho
I apologize for this rookie post.

What do you all recommend for a procedure to adjust the air fuel mixture?

My emissions manual has me slightly confused and my other manual recommends using a vacuum gage which I don't have. Maybe I need to acquire a vacuum gage?

Thanks for your help!
 
Ken (Romer),

Had your FAQ printed and in front of me Saturday - adjusted my carb as per the FAQ and worked great. Smooth idle now at about 500 rpm and good vacuum (18-19) across the board.

Sweeet. And Thx for the FAQ.

Only PITA is accessing the carb adjusting screws. Had to go get a flex-shaft driver to get the screw driver bit onto the adujstment screws. Then lean in and over the carb with the radiator fan blowing pleasant smells on me. Not too bad though.

AndrewT
 
Get a vacuum guage at AUtozone, they're cheap. Hook it into manifold vacuum via the hose off the manifold that goes to the brake booster. Also get a carb adjusting tool; flexible and makes things easier. The mixture screw is on the passenger side of the carb and the idle screw is on the firewall side (low); the choke limiting screw is also on the firewall side but higher up and more visible.
 
NJFJ40 said:
Ken (Romer),

Had your FAQ printed and in front of me Saturday - adjusted my carb as per the FAQ and worked great. Smooth idle now at about 500 rpm and good vacuum (18-19) across the board.

Sweeet. And Thx for the FAQ.

Only PITA is accessing the carb adjusting screws. Had to go get a flex-shaft driver to get the screw driver bit onto the adujstment screws. Then lean in and over the carb with the radiator fan blowing pleasant smells on me. Not too bad though.

AndrewT

Thanks, Most of the credit goes to Treeroot and Idave. My contribution was the sponge. Couldn't get my hand to adjust the mix screw with the filter in place.
 
Back
Top Bottom